Viewing all customer Discussions for:

Door & Window

I need the white plastic housing and wheel basically everything for two wheels and will order an extra likely.

I need to replace both the left and right side window tilt latches on this Certainteed vinyl replacement window. looks about 5 years old.

I believe this is an older aluminum window glazing bead wee need for a customer and I cant find anything similar to it. Can you help me?

Requesting part identification assistance.

I need to replace the window balances. They measure 28" and they are labeled 2740. I would like to have them with the plastic fitting already riveted on the ends but I don't know which ends to get them purchased with. Attached are photos of what they currently look like. Thanks in advance! ... (cont.)

This is from a wooden,single pane, double hung window circa 1978. It is a metal air seal between the horizontal portions of the windows where they meet. It slides into a kerf or slot on the upper window. It is 1/4 by 3/8 by 1/8. Both edges are turned under/folded over by 1/8. Do you have one of thes ... (cont.)

Please see the attached pictures of my window aluminum guide runner (measures 1/8")and nylon roller assembly with metal wheels. Will your guide runner (your part #87-206) work with my current windows of this have nylon roller assembly with metal rollers (looks like your part #87-175). Or do I ... (cont.)

I just purchased the model 39-411 operator and am running into a few issues to use it a a replacement operator for my Marva windows: 1) The mount holes are too small. I had to enlarge them to 1/4" to allow the mounting screws to fit. 2) The arm is mounted on the wrong side of the lever. The arm ... (cont.)

I'm looking for replacement (plastic) screen tabs for my removable window screens. I would need approx. 30 tabs (two for each screen) I have attached photos. Please let me know.

my spiral balance for my vinyl window appears orange. its a 3/8" tube diameter and a 29" length. The windows shouldn't be very heavy since they only measure about 31"x34" and are 5/8" thick insulated glass. Should I just order the red ones?

This lock (from another window) has broken. Need a replacement for Florida Extrusion Inc. The photo sent of the specs say it is a series 2000, Milestone. The house was built in 2001. Can you help me get this part? Thanks very much! Chris and Sam

the unit has the markings on the side "28 6 IV CMC" the pictures I took are poor.

I'm not sure if the piece I'm looking for is called a pivot. I've uploaded a photo. Please let me know if the piece looks familiar and if you carry it. I would like to purchase a few. The one in the photo is damaged. Thanks for your time and attention

single hung windows installed in 2005 looks like made in 2002 looking to replace all parts including pivot bar channel balance has a d (b or 8) fo (4 or a) and 23c nothing on pivot lock shoes 16/32 wide 1 1/2 long and 1 1/4 across tilt latch is 3 inches long also need to replace pivot bar which sli ... (cont.)

latch sinks back into door when you try to close it. if I pull it out and shut door it will lock. Just not sure which part to order. Don't really want to pull it apart until I have a new part. Can't leave the door unlocked. If necessary though I will do it. Any help will be appreciated. ... (cont.)

Any idea? Thanks very much, Mark

I have a Wright metal storm door/screen combo whose retainer strips were always a bear and now don't work and are an old design. It used to work by squeezing one side of it into a 6 mm gap in the frame parallel to the insert ,on the inside, with the remainder lapping over the insert. The replacem ... (cont.)

the harvey tilt window believe the id is 02-01542569

1980s park model trailer

28D stamped on it, 29" I need to replace these balances on 8 windows