Viewing all customer Discussions for:

Door & Window

I am trying to locate a window operator that is designed like this- its dimensions match 39-005 approx. 4 3/4" to the outside bolt/screw holes, but its location of the turn device make it function much better than the design with it in the center. Can you help me?

I need to order several new complete channel balances for my kinco windows. The Part numbers I can find on the back of them are below: 29-6 HA2 CMC 2 29-4 FA2 CMC 12 I have also included photographs of them as suggested by previous strings. Can you help me?

I have a Alside not sure what model it is, but i believe it is a 5100 or 6100 series sliding door i just had installed. the problem was the previous Homeowner had lost all of the installation hardware.... like the rollers for the door, as well as all of the Handle/Latch assembly.. the installer call ... (cont.)

We have a Pella storm door that utilizes the above referenced locking mechanism. Are there any other handles for this lock as the handle interferes with my front door hardware?

Hi, I need 2 of the "j47" balancer and 6 of the other one. I can't properly identify them on your pages, your help is appreciated!

Hi- I need to replace a few pins for my window screens (windows are Marvin Infinity). The current pins are plastic with springs inside. Dimensions are as follows: Screen frame width: 3/4" Hole diameter: 5/32" Diameter of pin at hole: 1/8" Diameter of pin head: 5/16" Length of pin from ... (cont.)

Please help us to identify the correct latches for our insect screens. Thanks Eberhard

Hello, please see the attached images for spiral window balance 17" non-tilt replacement. Image 0035 is the best shot I could get of one still installed. Image 0038 is from one uninstalled. Image 0861 is top and bottom of uninstalled, and 0863 is width, but I think there is plenty of room f ... (cont.)

I need 8 sash guides.

Hi, What folding handle/cover works with the 39-014/13 operator? Thanks

Have a crank with "Wright" stamped on arm. "7702" stamped on base.

I broke a piece of my window and don't know what to buy to fix it... In the 2nd picture you can see a piece of metal that covers the hole that is in the first picture and I am not sure what that piece is to get. Can you help me? Brittany

Re:- patio door replacement lock. I have a DNS industries 'outside Pull' which has a 13/23 stamp on it and on the 'inside Pull' has a 16 stamped on it. Do you carry this?

Good morning! I need to replace an Andersen sash balancer with the numbers 11600-2 and D12 7#27 580 printed in it. I just want to be certain I am ordering the correct match.

Hello, I have the following windows that need new sash balances. Can you tell me what parts I should order? The dimensions of the windows are as follows: 36x53 20x49 40x49

How do I determine how many of these pins I need for each screen I'm building?

I was looking for 2 readily assembled replacement channel balances. While I was able to identify our channels as 12in wide, 28in long, with likely a 19-005 on top and stamped "2740 3SI AJ", I cannot match the shoe and subsequently any balance series in your catalog. Our shoe is roughly 1/2 in (9/ ... (cont.)

The 1995 Alcan windows, center and end clips are sunbaked and broken. The smaller clips hold the crosspiece in place. The end pieces look like they were a friction fit to hold the verticals in place. I'm hoping for some new ones, whatcha got?

We are in need of a pair of replacement brackets shown in the attached photo. It

Looking to replace this casement lock system. Thank You !