Viewing all customer Discussions for:

Door & Window

Hi i recently purchashed a set of series 500 balances. i measured the top balances as a starting point. 21" is the top balances lengthes for the top pane so i ordered that size. The brackets were missing as well so i picked the style that closely matched the brackets on the top which were two diff ... (cont.)

the black part to close and tighten the window

I need replacement rollers like the attached sample. Can you help? Thanks.

Need 4

I understand that the handle on the inside is wooden. What about the outside handle? My doors open to a deck and the outside handle is metal painted white. Is it part of the wooden handle set?

I need these tilt latches, they did not match upo any on your site, the holes are off center, there is LH and RH

Hello, I've attached 5 jpg files of my current "Mortise Lock" - two are of the lock in the door, and three are of the lock removed. WRT names, numbers or makrings found on my hardware: "made in the USA" "0399" < I didn't not attached the photo which has this marking - I can always send it ov ... (cont.)

Need window balances marking on the channel are 34 DS 48L This are very heavy windows that are hurricane impact rated. The length of the channel is 35" (Metal end to metal end)

Aluminum Frame, the corner and tilt look like they are a 95-168 and 95-015

I have a home in Florida's west coast and built in 2003. They used SIMONTON hurricane windows (aluminium frame)and I have 6 windows that fall down when you open them. the tensioners or shash adjusters or what ever they are called need to be replaced. here is the number that appears after the b ... (cont.)

Hi, I'm trying to find a window coil balance to replace the broken ones I have in two of my windows. See attached window model sticker and the balance itself. Will your S140-20 be a possible replacement? Do you have any suggestions? Thanks James AAMA MFG CODE: MTL-2,SERIES: 1450/1750, H ... (cont.)

This is an Outboard Recessed Castor (part#011-1528) for a Kawneer 1040 Mall Slider. Do you sell this part? Thanks, Tim

I think i need a tilt sash but which ones match through attached pictures? thanks.

Grip bar snapped off. Need a replacement. Couldn't tell if it was the 90-005 or the 90-009. What is the difference between the two?

Need to replace balancer on an Anderson double hung window 8 over 12. I have the part and there are stamped numbers on the metal case. They are: 11600-17 N1 11#33 3 84 Don't know if that helps.

I have attached a picture of our casement window operator #30841KL. Do you have a replacement part or know anyone who might? Thank you. Geri

I have Anderson 200 series narrowline double hung windows with the chord in the frame installed in 1986. I have screens with the closure snaps 3 to 4 inches from the bottom of the screen. Would like to know if the 59-250 spline and the 75-019 roller is what I need for rescreening.i am hoping this ve ... (cont.)

How do replace a Malta window latch? Do you have to re screen or do they just snap in?

I need a replacement door sweep for a Cole Sewell Fullview(Pella similar name) storm door the registration number on the door is 04300290035 0556. I am not sure where to locate the model number of the door. The sweep measures approximately 1/8(groove width) X 8/16

The window/Latch is from a builder grade window from about 1994 or 1995. The dimensions on top are 2 5/8" X 3/4". My apologies for the pictures. I can get better ones if need be. Thanks, Greg