Viewing all customer Discussions for:

Door & Window

Looking for two replacement window latches. The existing latches have hole spacing of 1 1/4". Body of latch measures 1 3/4" x 1 1/8". It has a spring loaded thumb pull to unlatch. I've attached photos of the one I have that's not broken along with both windows. They are hung windows that open u ... (cont.)

Hello, I am looking to replace this window lock. The only stamp is an outline of the state of Texas MDC 5 written on iot. The keeper is built into the window, as per attached photos, so that wouldn't need replacing. The actual screw hole distance seems to be 2-1/8", but we have replaced some with of ... (cont.)

I need the little clicky part that locks the window from tilting. I need 2 sets of them.

Please help me find this I've looked everywhere.

I'm not sure what's the name of that part of the window

Top of sliding screen door broken part

Just need right parts I know how to install.

My rollers look like your 81-078 except mine are 1/2 inch wide where yours are 9/16 inch and mine do not have the little bumps on the end to I assume limit the height adjustment travel although I dont think that matters.

I need left and right side

I can barely see part number It said 15 3 cp Caldwell

Windows brand: CertainTeed Size: width 48" x height 72" length of channel: 31 5/8" Stamp: 31 9 Need at least 2

Similar to your 39-054 product. Picture with dimensions attached. Could use three of each, left and right.

Crank can open window but doesn't close window. Wondering whether any of your awning cranks would work.

So, as you can see, two of these are rectangular 31-16 rods. No further information is discernible on them. The other is tubular and measures 25" without the tip, which measures an additional 1.625". It has no markings whatsoever. I need two of these tubular rods at this length, and two that are app ... (cont.)

Hello, I need a replacement for this balance, thank you.

Hello I'm looking for this latch

Looking for a pivot bar, 2 1/2” long, body is 5/16” wide, need the hole to be 2 1/16” from the end.

Hello Looking for a window crank

Hi, we have a older srping balance with a broken foot

Hello, I am looking for one of these.