Viewing all customer Discussions for:

Door & Window

I find no brand name on the window or glass. It is a vinyl window. I need to replace the tilt latches. There is a name on the bottom of the latch Active Co NY and a number. Any help would be appreciated.

I’m looking for a pivot shoe 1 x 2 x 1/4 It is 1" Wide and 1/4" Thick. 3/8ths thick Has a little bulge on the bottom. Thank you.

The one i am looking for is a round edge tilt latch , I don't exactly have all the dimensions but i think it is 2.6" long spring loaded. It seems to be the one that slides in.

On the casement operator, long arm is 13.5". Do you agree 39-406 makes sense? On the hinges, the base plate is 10". The window strip is around 7.5". The shorter bar back to the base plate is right at 5". Seems like 36-048 would be needed. These are all right side. If you concur, what are the ... (cont.)

Hello,I am attempting to satisfy a customers broken sash. Would you please help identifying the replacement parts required? There are a lot more parts required for this project, but this is the one I'm having trouble shooting.Regards,Danny

lever broke and assuming I need to replace the whole part.

I need help with this glazing bead. Can you guide me to the correct part?

Hi there,Love your new website look! I have window latch tilts that seem to fail often, these window latches have a spring that goes in the notch but the spring gets stuck in the enclosure bottom and the latch fails. Do you have anything that will work for me to correct this permanently, a self cont ... (cont.)

Hello I'm looking for this part replacement please it said 29c

looking for 6 of the clips in the photo thanks

The balance is 30 inches (metal only) long, 9/16 inches wide. The attached pictures show the ends of the balance.

J-B Weld didn't hold. Pella unresponsive and unhelpful. Didn't see a similar part on your website. Suggestions? Thanks.

Identify coil springs , availability, cost

Pretty sure the window is made by WARE, Miami FL. Control box is about 5.5". The box is pretty much empty. The piece that connects to the window is missing

Can someone please provide some insight on how to install 84-108 rollers. The roller has fallen out so have no idea how a new one goes in!

Printed on metal coil: #7.5 35” 672L Z 04/12/18 2 Need part identification help AND instructions on how to remove/install parts. window is a tilt in window. single metal coil spring housed in the long plastic part

Stanley door part #00-5024 thank you

We have several casement windows where the cranks have broken off. We have an old house with new-ish windows. Can these cranks be replaced? The picture is just 1 sample.

I have several windows that there are stains inside between the two glass and the windowpane and a couple of them pully system is not working correctly.

Hi, I have some large sliding windows with broken parts. I am attaching pictures. One is what I think is a device to allow removing the sash. It has a lever that snaps into the larger plastic piece, probably to lock it in the frame. The other is what that lever looks like once it has broken off. ... (cont.)