Viewing all customer Discussions for:

Door & Window

Balance coil on upper is marked 17. Lower balance coil is marked 14. I also need 3 sets for duplicate windows which are upper balance 15 lower balance coil is 13. Your quick response is greatly appreciated.There are two more windows upper is marked 11and the lower sash is marked 10.Jim ... (cont.)

Item is approximately 1"x2" with legs positioned width wise

Can you help me figure out if you have this window springThank youCory

The part in the photo is from a storm door -- I think it is a Larson. There is no identifying tag on the door. The part is stamped with the number 8232. It is used at the top of a storm door glass panel to slide it into a track and hold it in place. The door has 3 panels -- two glass and one scr ... (cont.)

Hi I need assistance finding the replacement parts for this active window that is very difficult to latch and also is not gliding on the track correctly. It's probably 10-15 years old at least. Thanks!

Channel length- 27 7/8" Stamp- 2750 Manufacturer- unknown Needed- 8

I am trying to find a replacement for the pivot shoe cam without having to replace the entire coil balance system on 2 window sashes. I would prefer not to cut the jambs or purchase the jamb spreaders but will do so if I need to.

Good evening. Most of our windows will not stay up anymore. I have taken this window spring out but do not see any kind of markings on it at all. It seems to be 1/2 inch wide and 30 inches long. I would just like to make sure I get the right ones ordered up. Thank you for your help ... (cont.)

Hello, i'm trying to understand which T seal for my window is the best. I'm not familiar with the measurement terms, so I included pictures of the measurements. Thank you

I'm looking for a replacement for a broken patio door top roller. The screen door hangs from two rollers mounted on the top of the door. The bottom simply has a plastic guide that fits around the bottom track.

Need both rollers for an Acorn Sliding Patio Door

The glass door is mildoor. The slider was installed with this screen in 1972. The wheels are no longer functional. Can you assist with this.

I have 29-5 LX CMC 11 I know what the 29-5 means, it is like your 2950. But what does the LX mean? And the CMC 11 mean? I also need (4)29-1, (10)29-2 and (14) 29-5 (Qty) all with wings top and bottom.

Can you help me get replacement for this crank hardware?

I would like to replace these casement window cranks with a part compatible with the encore truth folding handle product code 39-375 or the Truth Folding Handle And Cover Kit product code 39-107FK

I have a Trapp storm door with a brush sweep that is pretty beat up. I measured with calipers and the dimensions for the white square plastic that inserts to the door is .110" wide x .125" (1/8) high. The opening at the bottom of the door where the sweep inserts into is 1/8" wide by .145" high. The ... (cont.)

I think this is a 'Pivot Bar' It's located tawords the bottom of the sash and the end that sticks out of the side fits into the shoe that connects to the spiral balancer. I believe this is called a pivot bar(??) Are there any recomendations for replacement?

These are out of a milgard series 350 window installed in 2007

The square block on the corner is 5/16 inch wide 3/4 inch long on both sides. The arms are an 7/16 inch wide on the flat side. The inside of the arm has offset of 1/8 inch wide from top of the arm to the extension is 3/8 inch. The space between the top extension to bottom extension is 1/4 inch. I ... (cont.)

Can someone help me with this parts.