Viewing all customer Discussions for:

Door & Window

Good afternoon, I am searching for a replacement handle set. Any assistance is appreciated. Thank you!

Good afternoon, I am having a very difficult time finding a tilt double window closure. It's a recessed part and attached in the bottom side of the closure. I would appreciate any help you can give me. It is a wood tilt window. The latch mechanism has 1 3/4" hole centers the keeper has 1 5 ... (cont.)

Do you carry this clip to replace broken one

Crank operators are rusted and inoperable.

cascade window Model 9200-AT ARCH-TOP SGL HNG winpro series, NFD, 25.5Wx 101.75H, x 96.5 SL (see original invoice) Written on balance: 44-4 JJ5 CMC It's been impossible to find someone to repair the window.

I am checking for the window channel balancer. It is 23 inches if I read the marking right before I "shoved" it back in. LOL Do you have and if so how much? I will be in Florida shortly for 10 days.

Bella 20 SERIES window sash balance replacement/Window sash balance

I need 10 in Black

The glider at the bottom of the patio screen door.

Looking for replacement window cranks for 1970 building. No markings, nothing on the cranks.

I was not able to find a part to match these either of these part numbers. The bottom piece did not look like any of the products you had on the website. Could you please assist as soon as you are able?Feel free to give me a call

Window lock

Approximately 20" wide casement. Looking for both upper and lower arms.

Will 95-020 work as a replacement corner bracket for this unknown plastic corner bracket? Measurements seem the same, though no width is included in the photo on the item page.

Hi, I would appreciate help identifying the following parts so that I may order 6 of each.Thanks!Bob

Hello, Would you be able to match this pre-2001 bright brass patio door handle? Thanks!

4 inch high and a 1/4 inch wide also the pin that goes into the window is 2 3/4 long x 1/4 wide

Here is my door mechanism with a broken latch. Two screws go thru the mechanism and tighten without exiting the other side. I would like to replace the brass plate and knob which turns the mechanism.

I need one of these

need operator for a casement window. all I have is number from window. C1409553304334