Viewing all customer Discussions for:

Closet

Need replacement bottom pins and a couple plastic sliders for the bottom rails. Pic1 shows top pivot pin (which I have all of), pic 2 shows bottom of a door, pic 3 shows the one bottom pin and the plastic slider that it snaps into. The rail is at (or just over) 7/16ths inch wide. The pin is 5 1/4 ... (cont.)

Any chance you have this part, please? Thank you. For my Dad.

I want to buy 6 kits Cox 21717 21767 with concave roller, pse inform us avaiability, cost per unit and estiamte time to receive them.ThksDaniel

The stationary pins seem to be OK (although I should probably replace them also) but I need the assemblies for the parts that slide back and forth in the track - both top and bottom are gone. Can you please identify what I need to buy to re-hang these doors? They are quite old and don't match the ne ... (cont.)

Hello. I am looking for replacement upper and lower roller hardware for an old bypass closet door. The door itself is quite thin and the rollers look smaller than the other rollers you have on your website. The bottom piece is 4.25" by .5". Can you help me locate a good match? Thank you. ... (cont.)

Need replacements

Johnson series 1825 60"

I Have a Leigh Product Bi-Fold Full-VU door and the Bottom slide broke will this 21/203 Pivot Bracket repair It? It looks like it might my house has several of these doors Here is a picture of it thanks in advance Gene

Hello I am looking to replace my track top and bottom for my 61" doors.

Nylon top block that goes in the rail. That excepts the pin from the bifold door!

What is the difference between part 23-240 and 23-242? Is it only the length?

I am interested in buying this item in the Satin nickel color. Could you confirm the exact width of this track?

Hi there -- What are the pins that goes inside (or compatible with) the corner block? We need to replace the block and the pins. Thanks you!

What is the whhelnofset measurement? 1-1/4" inch.... wheel to wheel (in other words track offset?) I have 1-1/4 wheel/track offset . I could purchase if wheels will fit. It looks exact match

Hi,I have this Paniflex Closet Door System. These closet doors only have the top track and no bottom tracks.For one of my closets, the 23-099 Paniflex Center Spring Loaded Roller does not sit high enough to stay in the top tracks. Perhaps the door is too heavy or the mount has now been tilted that t ... (cont.)

Do you have a match or any univeral wheel assembly like this one?

Hello, I have these mirrored sliding doors I bought 35 years ago. On the back of the mirrors a sticker says Marshall Aluminum Products, Irvine, Ca. I need the 4 inch bottom track. Can't find much about Marshall, maybe they went out of business???? These doors have the concave wheels that roll o ... (cont.)

Hi. I am trying to locate a piece that will keep the sliding mirror door on the track. Please see attached pictures.

I was called out to troubleshoot this set of old bifold doors today. The doors are 93 and 1/2 in tall and about an inch thick. The doors fit in the 4-ft wide opening. One of the doors is off track, and the other one is on track but it seems like the sliders are not correct for the track. I would lik ... (cont.)

I have a 36" bi-fold door replacement track which I just ordered from Swisco and installed. The door opening is about 38" wide so it was installed centered with 1" gap on each end. As you can see from the photos, I have a spring stopper which technically isn't needed (i.e. it wasn't there before). ... (cont.)