Viewing all customer Discussions for:

Closet

This roller is from a 2011 Fleetwood Bounty RV. It appears to match your 23-225 roller. Would you agree? Chuck

I have these old wheels on closet doors. The wheels are flat and no longer turn well. The doors are heavy so I like the "strong" designs. I am not sure how to measure the off set, but I think it looks like ¼" and the wheels look like they are just under ¾" I need 12 replacements? Or lots of (24 ... (cont.)

Looking to replace bottom track for contractors warehouse closet doors #2038198.

I've got a sliding closet door and we're missing one of the rollers to it. Any help figuring out what to buy would be great. There's a sticker on the back of the door that says 'warranty #020188' and then in bigger writing next to it, '0929898.' Any help figure it out would are great!! ... (cont.)

have a old sliding mirror door and the guide on top broke

Looking for top plunger guides for bifold doors circa 1974. They have a ridge on them and I cannot find any to match. Please see photos.

I have a metal bi-fold door and it's hanging up I don't know if the bottom pin should have a bushing that goes on it to help glide along the bottom track.I sent two pictures the one mounted to the door is the pin that goes into the guide hole,the other is the pin I think needs a bushing ? Thanks Tod ... (cont.)

Hi, I have a bi-fold mirror door. There are top and bottom pivot pins attached, as well as a top guide pin. I found a loose/detached pin which appears to be the bottom guide pin. It's 4-1/4 inch long without any threads or cot pin hole. I need help finding the missing parts to put the pin back in pl ... (cont.)

I'm looking for a replacement wheel but I don't see anything like that in your catalog. I believe your recommended replacement for the entire assembly is 23-222C. I don't see that the wheels on 23-222C are offset as in my picture. Are they adjustable to allow for the offset? Thx K ... (cont.)

Have a questions about the installation clip on part 21-044. Does that clip fit between the spring and the bottom of the metal frame or does it sit on top of the pivot pin? If it clips on top of the pin, should it be flush with the metal frame or above it. Trying to figure out exactly what that c ... (cont.)

I am looking for a two pivot guide rods for my bi-fold closet door. The door was made by National Bifold doors. You can see in the images the length of both of them. The one above the measuring tape is the top guide rod. The one below the measuring tape is the bottom guide rod. Then there are two s ... (cont.)

Do u have a bracket for 36" bi fold door

We have a mirrored closet doors that have a very rusty track. The track is 60 inches long and 3 1/2 inches wide. We would like to replace it if not be too expensive.

NEED HELP TO IDENTIFY AND OBTAIN REPLACEMENT UPPER AND LOWER ROLLER ASSEMBLIES

I'm looking for this type of door roller that I need to replace.

I'm looking for a replacement pin for my house closet doors. Its the bottom pin the closets are about 50 years old or older

But how does 23-041 stay in place without the anti jump safety clip?

Is there another option in lieu of aligners that can be used on Bi-fold doors?

Looking for part US Pat 4850145 or comparable. The wheel has broken off the part I have.

Goodday!I need replacements for two STANLEY Parts here in The Netherlands.Much obliged if you can point me in the direction of a firm where I can order these.Parts:top little wheel Stanley 3022 4019000bottom big wheel Stanley 4010x2RPicture included.Thanks in advance,MtB.