Viewing all customer Discussions for:

Closet

I have a Monarch Mirror Door and one of the wheels are missing. The door is over 20yrs old but in good shape, can anyone tell me if or how I can replace it?

Replacement rollers for mirrored closet doors.

Part is for a closet folding door, unfortunately no part nos. or names.

The guides are flexible with an odd shape. They fasten to the tops of the doors and they keep the doors centered and sliding smoothly inside the top rails or tracks. They bear none of the door's actual weight. Over time, they deteriorate from flexing and perhaps loss of suppleness. ... (cont.)

I've got an "oversized" rough opening that has jamb installed. The desired bifold has a gap on both sides and in the middle. Is it acceptable to use a "stop" i.e. Molding at each jamb side so that when I adjust the door in the center the gap on each side is not visible ?? Opinion would be appreci ... (cont.)

I see that your 23-510 track should fit the door I have but my doors are solid oak raised panel and I believe they weigh more than the 30 lbs. Also I would prefer in brown. Can you help?

Is your plastic Closet door guide 23-207 a direct replacement for the old metal/plastic guide 23-265 ? Thanks Michael

Swisco, I need a new bottom track for a sliding closet door, not mirrored, which rolls from a wheel track above and glides with a straight plastic glide in the bottom grooves. Photos attached. I've identified this (60" SLIDING MIRROR DOOR BOTTOM TRACK Product Code: 23-241) as a likely replacement ... (cont.)

I need to replace two tracks of my closet. I am sending photos of the tracks I have and the rollers on the door. Would your tracks fit the rollers on my closet doors? Tracks need to be one 78 1/2 inc other 78 3/4 inches Thank you for your help Fara

Hi, The plastic wheel to one of my closet mirrored sliding doors broke - it's 1 1/4" diameter. Nobody knows what the part is (took it to Home Depot and a specialty doors place) because there are no markings. the 'top' part is shown on the left each time, the rubber portion is stamped 'COX 21-707'. ... (cont.)

Please help ID track pictured. I am being told that the door has Acme listed on it. This track may be discontinued, if so please list a possible replacement. Thank you for your help.

Hello. I hope that you can assist me in locating this part.

Goes on top of mirrored closet door. May be the original equiptment for home built in 1960. Thanks for you help.

Need a replacement. Top of closet door.

the picture displayed for your 23-043 is the same style roller assy that I need.However my wheel is only 7/8th OD the body is 15/16" long 7/16 wide and the with of the roller is 1/4" wide. can you provide me with any information on how to get them I need 2 assy Thanks - for your time ... (cont.)

I'm trying to repair 2 Benchmark steel bi-fold doors. One is 3 ft wide by 8 ft tall; the other is 2 ft wide x 8 ft tall. The top pin on the 3 ft door needs replacing (on the leading edge) and the top and bottom pin on the 2 ft door needs replacing (on the leading edge).

In search of this roller from hanging sliding door, house is 1955 rambler. It has a 1 1/2" recess.

Order no 800706 either has wrong product or I ordered wrong need 3 1/2" track rather than 2 1/2" track Item # 23-240. Length is fine. Width is 1" wider w wider slots than what I received. Pictures of what I have vs what I got.

I am searching for a kennatrack series 400 pocket door mounting bracket (part #25041) or something that is comparable to that Could you please offer some assistance? Thank you for your help Alison

What is this part number ?