Viewing all customer Discussions for:

Drawer & Cabinet

I have inherited 2 broken rear drawer sockets. I do not know the manufacturer, but it is certainly an older drawer guide. The inner dimension of the socket are 1/2" X 11/16" and a depth of around 1 1/2". These sockets slide into another bracket that mounts to the back wall, however, I believe I cou ... (cont.)

The inside plastic horizontal piece of the part came off. Does this snap back in to the other plastic piece or do we need a whole new part? Thanks

Rear door glide R-26 2856233, I found this in the blog, but cannot find it to purchase. is it available for purchase?

I am looking for a I am looking for a plastic replacement bracket for the back of a kitchen drawer. Is this something you could help me with?. Is this something you could help me with?

I need to purchase the medallion behind the glass draw pull and the draw glide on a Pulaski night stand. Please see the attachment. Thank you Rick

I have a broken hinge on what I believe is a Homecrest Kitchen Cabinet. Attached photo of hinge.

Hello. I am looking for a replacement part for an existing kitchen drawer assembly. I don't have much information on the assembly, as I did not install it. But it should be pretty straight forward: I am looking for the rear L bracket that the drawer roller guide rests in. This L bracket screws into ... (cont.)

I have a Gillingham walnut dresser from the 1970's ??? The read drawer guides are broken. I'm pretty sure they are the 32-030. The front side guides are broken too. They are white plastic in the form of a square C. The bottom horizontal arm is about 7/8 inches. The top horizontal arm is about ... (cont.)

Looking for socket possibly by Merillat. Says Unigrass 6600 on the rail. Some say they use the Knape & Voqt part 1805-101WP as a replacement. Is this OK? What works best for these socket replacements? It looks similar to the Swisco 220X200 & 493X317....not sure what this means. Our hou ... (cont.)

Your 32-312 looks very close to what I have been looking for. The only difference I can see is that yours is thicker at the top. What are your thoughts. Thanks

Great to find your store and this discussion: discussions/Cabinet-Part-77-39537 -- I am going to order 4 of the 1" Drawer Slide Spacer Product Code: 32-339 *SEPARATE QUESTION* - I have a large/deep drawer under my oven for racks, pans and baking sheets that stand on-edge. There are several 1/4" thic ... (cont.)

Hello, I am looking for a replacement drawer socket that has broke. I have attached a few pictures of the socket and hopefully you will be able to help me with finding this part.

sockets slide onto a 1 inch metal 90 degree angle at end of back bracket ,the slides on the sides, slip into the sockets.

Looking for one of these replacement parts for a Childcraft dresser.

Can't find need to replace

need to know thickness of slide pad

This is a bracket for a corner cabinet

spring loaded safety stop to keep the draw from pulling out all the way

We are a medical facility and in both of our c-sections room we have built in SS cabinets with doors that work with sliders. The slider bracket works with a roller. The bracket is a Grant Rocket #1012 (1/4" offset and roller is 3/4"). Note the attached pictures. We are looking for 32 replacement ... (cont.)

Good morning, I need to order some drawer guides for my Bassett chest of drawers, however I can't figure out which part number! Can you help? Thanks!!!