Viewing all customer Discussions for:

Lavatory

Will this shower door drip rail fit the delta neo angle shower door?

Part goes in bottom of door and guides in a track

Can 10-327 be cut for 24" drip rail? Thank you for your time Abbye

I need plastic door guides for shower door, a total 4 picture included to help you I'd.

I am looking to purchase the 10-324. Our framed shower door is 5/8 " thick and has never had a shower sweep installed. How many screws do I need and would the 3/8 pan head screws that are suggested purchases on your site be sufficient?

Greetings,The # in the "Subject" line above is the only thing I could find on the glass of the shower enclosure so I hope this helps to identify the parts I am looking for.I would like to order 2 each of the following items:1)The bottom of the shower door has a "J" shaped hook that rides a rail and ... (cont.)

Looking for a replacement part. Door is about 29 1/2" wide and the sweep is 28 1/4" long.

Chrome color. i'm guessing 20 years old. All stamped NA 81. two inches between screw holes. One piece is a handle only and other one anchors the two towel bars. I have the bars.

I got a Manhattan shower that was disassembled and a few parts were damaged. I need 3 pairs of this screw-sleeve combo used to hold the glass panels against the shower walls. Note: I identified a few other parts on your web site but could not find these screws and sleeve.

Hi, I have an Aquaglass shower stall and need the rubber replacement gasket for the door bottom. The current gasket is brittle and preventing the door from closing. Appreciate your guidance on a replacement part. I have several pictures in a Google photo album located hereThanks! Tim ... (cont.)

How do you remove a broken 10-076 roller assembly and install a new roller?

3/4 inches long gas is 1/2 in inside

I'm just trying to find a solution to fix problem or replace if necessary.

looking to purchase replacement rollers as the bearings are shot. will purchase entire assembly if we cannot just replace the wheels.Apparently this is for a Mirolin shower door purchased in 2009

I?m looking at replacing my old drip rail and sweep and I was wondering how tall the sweep is and can it be cut down if I don?t have much room under my shower door?

Hello, I'm trying to find a plastic replacement seal for my shower door jamb. Attache please see a picture of the groove the seal is threaded into.

I'm going to order the 30" and cut to fit, but when installing should I install the rail slightly angled so the water drains to the door hinge side? Thanks Mark

Replace bracket at bottom of glass door holding glass in place.

Spoke with Jim. Thank u. Fred

Hello I?d like to replace the attached rail and shower door sweep, it is 21.5 inches long. What do you recommend? Thank you Robin