Viewing all customer Discussions for:

Other

Long arm 40753,short secondary arm 31539, shorter attached pivot arm 20748. I need to order 1 assembly.

My sons dresser drawers need your help. The dresser is the Young America collection and the set is still so nice. I am looking for the plastic pieces to stop the drawers. Thank you !!!

I have ordered from you before about a year ago. I have two Vinyl double hung windows that my tenants are rough with. These parts fell out of the tracks on the sides. They keep the windows from sliding down by themselves. Do you have these parts? Thank You, Shawn

Need two lefts and two rights

I am looking for a replacement for a spiral window balance (see photos) 30" length Green tip looks like a 1/2" diameter? Also need a tensioner tool Can you please assist?

I am replacing the quick tilt assemblies inside one of windows that is completely destroyed. I need to know what parts I need. Please see pictures and advise. Please note that the casing around the springs have the number 4 on one casing and the number 8 on the other.

Do you sell this plastic door glide?

3/4" WIDE/DEPTH 1-1/4" HEIGHT (Total) 30" LONG

Dear Sir/Madam, Our window is hard to be left also will not stay at left position. After took the sash off and found springs on both side are damaged, each side has two pieces of springs. I can only find "MEGA 6.5 33""makings on one piece of the spring and can not found anything else. The sash siz ... (cont.)

Hello , I need the following replacement parts but can't find them. Would you guys be able to help ? Thank you

Sliding door sold/installed by "Cost Savers". Multi-Point Mortise Lock with installation holes separation of 12" Markings on the lock are: - Aug 15 - PAT# 5.820.170 - PAT# 6.264.252

STAMP ON THE METAL IS 2720 B.S.I. R I NEED 2 pieces , It look like a TOP FITTING , Length of the metal channel is 28 inch.

I am looking for several pieces of this part for a 3 glass window awning? Please help.

Did not find any marking on window at all. Old style window. balancers are inside of side jambs. The window sashes are tilt out and need to both be removed to then remove side jamb where both balancers are then slid into the jamb from the top of the jamb.

Multiple pictures for inside, I need the top bar attached to vynl the end of it the pins into small black part with hole in one end, pin in the other witch is attached to bar. The pin rusted out completely, and snapped.

I need to replace the coil on both sides of a single hung window. Both coils are broken. Window sash weighs about 13 lbs and is 23.5 inches high. Probably just need coil replacements. Coil is 1/2 inch wide. Looks like Series 175 silver. Shown in the picture are the bottom shoes and the broken parts ... (cont.)

Channel lengths are 29". The existing marking is 2820 but they are very difficult to push down (sashes are light). Need to know which series to purchase

Hello. Looking for any idea how to find replacement part for this window part? I am able to swap out with existing/functioning window, but may eventually run out of options. The twine snaps on these and makes window inoperable. Contractor told me I would need to replace the whole window which seems ... (cont.)

Hi Swisco, I have a right side crank operator arm that is jumping loose and skipping out that only opens the window a couple of inches. There is no branding or numbers marked anywhere that I can see. I did include a photo of the left side operator that is properly functioning. It is a brown Pine Cr ... (cont.)

Need new window opening part