Viewing all customer Discussions for:

Other

Hi There - I am trying to find a replacement handle for this IWC sliding door. This is the non-locking side which should be pretty basic but, I am having trouble locating this part. Can you help me figure out which part this is?

Do you have a replacement lock for this type or sliding glassdoor?

looking for the attached.Steve

I need to replace my Tilt Window Latch on my H-R25-46x77 window. I believe I will need the 26-243 and 26-244 tilt window latches. I attached photos of my current one. length is 2 5/8 in width 11/16 in the height looks to be 3/8 in Thank you!

the bottom part of the bracket has snapped off and the the drawer is not closing properly now. Do you know what bracket this is? Or what replacement bracket I would need? Thank you for any info.

I need snapin window glazing bead that was damaged during a hailstorm. 60 feet is what I need.

Hello there . The only Marking there is on the WB is 7 lb The window is small double hung window 30" x 36" Thank you

Hello, The nylon wire has popped in a couple of my balancers, so I would like to replace them; however, I don't know the part number of either the wire (assuming it's field-replaceable) or the whole balancer assembly. I also need the clip in the window channel that can be seen in image 6024 attached ... (cont.)

Hi Sir looking for door lock and roller for attached picture please help

Before I buy these I want to make sure I am buying the correct one. Btw your website is EXCELLENT. So it looks like 1/2" 16" long, 1 1/8" bottom shoe, 1540 stamped. So is it #390?

I need one left hand and one right hand coil balance. It may be hard to see in the photo but the number "8" is stamped onto each spring.

Hello I am looking for two replacement crank handles like the one attached. Do you happen to know where I can source them? Thanks in advance Bev

Hi,Looking to replace these Truth Entry Guard 40471 window openers with slides since rollers are worn. Would also like handles that will fit Mortise Lock, square face, 3-11/16" item number 82-223. Additionally need the inside latch for this lock- you previously sent lock above, but no latch. Thanks ... (cont.)

I'm looking for the side jam and header seals. Might be called a Kurf seal or kirf- in seal. See pictures. It's for a crestline Sliding patio door. Purchased 2002-2003.

works with 82-238

Hello, see attached photos. I am looking for a replacement. Depth ~0.5". Length of channel 30". Thank you for the help :).

Hi Swisco,Do you have the attached shoe in 1/2"? I purchased the 9/16 but they are too tight and the shoe does not travel easily up and down the casing.I also need to order a new casing. Do you have any idea who sells side jamb casings?ThanksDeb

Can the brand a retailer be found based upon the pictures attached?

Hi i am looking for parts Balance assembly, pivot & shoe double hung Simonton 550 Replaced all windows in 2009. Last year when opening windows. Two of them parts flew out and either the top or bottom slams down.This year it happened to a few more windows. Attaching pics In need of the entire ba ... (cont.)

I would like to replace this clamp style handle for a sliding glass door, but I would like the exterior part to be pretty much flush with the door rather than extending out like this piece does. I am installing a sliding screen door and the current piece (the really worn looking one) extends too far ... (cont.)