Viewing all customer Discussions for:

Other

I cannot find any mfg info on these windows. These plastic spacers snap into a groove on one side of the inside edge of the window frame and up against the frame of the window on the outside edge. The dimensions are 5/8" wide, 1-1/2" long and 3/8" tall at the highest point. 152545 shows the screen ... (cont.)

We are trying to figure out what part we need to replace the rollers on the screen door the salt water rusted these.

please advise if these latches are available in stock . and the colors availablethanks

Hello, I am looking to replace the weather stripping.

Sliding door handle. Screw holes 3 14/16. Length of handle is 8 inches long.

These little plastic guides are breaking off. They keep the window straight in frame when raising and lowering. The measure 3/8" x 3/16". Thank you.

This top sash guide is from a window that was installed circa 2000. The label on the window is a Lawson SH-7500. My confusion is that the part #18-192 that you show is different than this part. Currently, I need 2 of these but I would like to have an additional 8 as backups.

Please advise on the correct window operator. Long arm #40753 and short arm # 31538A. Looks like long arm from center of the mounting hole to the end of the arm is 10-3/4. Short arm from end to end looks like 4-7/16. However the arm looks to be angled up Your Part number 39-031 indicates the link a ... (cont.)

Looking for replacement rollers. The roller assembly is attached with two screws to the bottom of the door frame

Could you recommend a replacement for this Mepla kitchen cabinet hinge (installed 1993)? Thanks, JM

Hi, We're looking for this rubber seal for our GU supplied doors... but can't find this online, can you assist please? Kind regards

This part is from a Pella sliding screen door. Part says patent pending

Need to replace the window crank and mechanism. See picture

I am looking for this window is certaiteed

I need to replace these window balancers. I need:(6) with the numbers 28 5 inscribed, 29"(4) with the numbers 28 3 inscribed, 29"(2) with the numbers 22 3 inscribed, 23"All of them have the same end piecesThanks for the helpGreg

I am trying to replace broken kitchen cabinet hinges. They don't have to be soft close.

I need five of these. They have all broken off because they are plastic. If you have any thing stronger that would be great but anything will do. The screw holes centers are 3 1/4 ".

I need two bronze covers and cranks as well as two bronze locking handles to replace white ones. The window is a double Marvin casement and aprox 10 years old. Screen says A-X7164R but can't find any other markings/stickers. Thank you.

Mortice hole in door is 4-3/4 tall x 5/8 wide x 1-1/2 deep. No visible part # to reference on lock.

I need to upgrade and replace the old Anderson cranks with nesting cranks in bronze. The dimensions are 5 1/4" width and 1" height and the crank length is 3 1/2". No visible screws.