Viewing all customer Discussions for:

Other

Replacement right latch. Also would like to purchase right and left sides to keep for future problems

I need to replace the part above. The metal part is 28 inches long (This excludes the plastic parts on the ends. The channel is 1/2 inch wide.I did not see writing on the metal piece.

Sorry I don't have installed pics of this. One has a broken cord and I pulled them both and brought them home.

I have new Simonton windows, and our builder didn't leave any spare parts. Wee have a vent lock that broke on one window and needs to be replaced.

I am unable to find this specific part of the handle set up. I saw a post someone called it the backing plate for the interior handle.

I hastily order what seem to be incorrect parts and are returning them for refund. I need guidance on the proper parts. 1 - Pivot Shoe I think I found correct one (your part # 15-046) mine pictured in 2 inches H, 1 1/4 W and 1/2 inch thick. 2 - See photo of the spiral balance - I purchased your S9 ... (cont.)

I'm looking for replacement pins for these windows , tilt sash double. I've pulled both upper and lower and cannot find a manufacturer Length 3 1/8 Holes from inner end 3/4 and 1 3/4 Thank you

Pictures attached Manufacturer was MI Windows and Doors House built 2014 Windows are non-tilt I have 6 windows. 3 of 2 different sizes Picture taken from below shows an angled piece. This piece has hole for tool to grab. Do I just grab it and pull down? after releasing tension do I twist 90 deg s ... (cont.)

There is a "L" stamped on the bottom for what I would assume means Left. It is bronze in color and the arm is about 11"-12" long.

Only markings I see is 45411 on bottom of gear piece

Hello, I'm trying to locate a replacement spring loaded track guide for a set of fold out closet doors. The photos are of the existing good part. There is a spring loaded pin at the top of the door that goes into the sliding guide. 2The only identification found anywhere is on the door hinges, ACME ... (cont.)

Please, I need to purchase the track for this door (2) the length is 65" or bigger, I can cut, please let me know if you have in existence.

Looking for this part or or a way to fix it

I have that parts broken, I need replace about that part in about 5 windows.

Circadian 2007 sliding door weatherstripping that needs replacing. Trying to source the correct parts

I need new door handles/locks for two Larson Storm doors: deck and side doors. Deck Door The number on the inside sticker is 34660081.122 0707 23 I would like it in the color black. If black is not available, then oil rubbed bronze. See two pictures labeled "deck door". Side Door The number on ... (cont.)

These rollers are from a Fleetwood Window roller

no identifying markings. Piece is 9/16" wide and 28" in lenghth (metal portion) The window is 11.6 lbs. Which channel balance do I order ?

I am looking for replacement slides that would work for my dresser. Brackets are slim. One part is installed in groove on draw and then other piece on the dresser itself. Would these slides work? Furniture was made in Italy. 30 years old. Thank you

Where can I find this bracket? Do you sell one that will work?