Viewing all customer Discussions for:

Other

Have a tilt window with broken spiral balance on right side. Various connecting pieces broken both sides and on the window itself. I can identify the pictures if needed. I had 10 pictures. Hoping to sent the rest in 2nd message.

Balances are 23" long, app. between 1/2" and 5/8" wide they are stamped "22 3BSI"The latches are 2-3/8" long (not including the "tongue") and 5/8" wide. I need one pair of latches and one pair of balances.

The door was heavy, and I didn't take the dimensions for these rollers. looks like this might be a fit:81-167

I have a number of PVC framed casement windows that latch with Truth 45085 handles. What I need are the mating piece (keepers?). The part attaches to the frame with one screw at the center, to the side. The part is 2 1/2" tall overall with a 1 7/8" opening for the latch. It's 3/4" wide overall an ... (cont.)

Aluminum frame window (circa 1980). Screen frame locks into window by metal swivel attached to screen going into groove in window frame. It is flat, except for part to push, so it is flush against to screen frame. There is a small Teflon washer acting as a spacer to limit screw depth into screen fra ... (cont.)

Looking for a piece like this that broke on my center mount guide it was the end piece that held the guide from falling out going up

Hello, This picture is from crank out windows on a sun room. I don't know the manufacturer. Thank you for any help you can give me.

My neighbor had a kitchen drawer rear bracket break. It does not screw into place, but is a friction fit into two predrilled holes into the back of the cabinet. Manufacturer is unknown.They appear to be me from plastic/nylon. They were installed approximately in 2006-2007 after hurricane Katrina He ... (cont.)

To whom it may concern Please tell me the part number for these pins, thank you, I need about 10 pieces. Sincerely, Patrick

See subject and photosThank you, JERRY

I'm looking for 4 balancers for these windows. No number on the balancers.

26 6 do cmc 10

My windows tilt in and bottom sash is removable. When tilted in, they lift out of a sliding part that has a string along each side of the window. There are 2 metal parts that are t-shaped attached to the sash that fit into the slides. See the attached picture. They feel like cast aluminum. I on ... (cont.)

We have large sliding glass doors and one handle is damaged. I would like to replace the handle. I can't find a manufacturer on the glass doors, but the attached screen doors say 'Aluminite'. The handle says 'Made in New Zealand'. I wish I could find more. One thing I *do* have is a work order numb ... (cont.)

Black plastic track part which hold roof window in track is missing so can you get me this part

Looking for rail and case runner for Ashley furniture B533-31. Could you point me in the right direction?

Looking to identify the replacement sash balancers for an old Anderson doublehung window. Thank you

2 doors four rollers total. no names, numbers or markings seen. Wood doors with pockets that rollers press in from bottom. metal wheel. the doors have aluminum cladding on exterior.

Hi. I need two new channel balances for a sash window. The markings on it says 26 4 HN Caldwell. The length of the metal channel is 27" long. Can you tell me the replacement part I will need? Paula

We need to buy a new latch for our screen door from Cole Sewell.