Viewing all customer Discussions for:

Other

2inches long 1-1/4 inches wide 1/2 inch thick. Need a replacement.

I am looking for a replacement window crank as shown in the photos. Hopefully you'll be able to identify a replacement part for me. Thanks!

I have a 26 inch balance with a 1/2 inch in width. It is stamped with 2530 bsi.

I'm looking for replacement window cranks for windows that are at least 25 years old. Hopefully you will be able to identify a crank I can use in these windows. Thanks,

I need three of these tilt window pieces.Can you give me a part number or connect me to order.Thanks,Jon

I need to replace the shoe for my window and want to make sure that I order the correct part

I need 1-1/8 in OD steel sliding door tandem roller assembly with F-Tab see photo I need 3 sets for three doors or replacement rollers for all 3-doors(12) wheels

Looking for replacement window parts window balance spring as pictured below. Need 3 .

Can you identify and do you stock this patio door handle. It is from a Pulte house built in 2012.

This is part of the track. The hard black plastic piece is broken and the arm does not connect. The arm adjacent to the black piece is etched with the brand Del Mar Toronto. I would like to order that part.

Turning the inside nob -lock- doesn't move the 2 locks on the Aside patio door. They don't seem to locked but the nob to lock the door doesn't work. The length of the lock is 12.1/2" metal to metal. Any help is appreciated. Carol

Dear Expert, Here is the measurement of my channel balances and the pictures of the shoe, top, and stamp, please help identify the part. Channel length 26" Channel width 1/2" Depth of the show 1" Marking: 25 3 GS CALDWELL Problem: the Nylon sash cord broke, would like to get a pair of new channel ... (cont.)

Window produced on 6/13/95 (#9506130841).I have attached pictures of the clip and labeling. I need both the left and right clips (two of each).

Do you carry this part?

Needing to buy a new window balance. It measures 5/8" wide and 32" metal to metal. It's stamped 31 2 HP Caldwell. I have pictures of the ends.

I have PGT windows. The bottom panel moves up and down. This movement is guided by two small plastic guides in either lower side of each window. Over the years, these broke off and now the windows do not go up and down in a straight line and sometimes het stuck in a tilted position. I am looking fo ... (cont.)

Hi Team, I am looking for a replacement part for the attached channel Balance. It is for Single Hung Window. The marking says "29 4 FV CMC 7" Regards Samir

I need to replace the rollers which I think I can do with an assistant. Can you identify from the photos what make door this is? The house was built in 1955 in the Bethesda, Md. area. From the drawing I can tell that the windows are AlWinTite but there is no indication as to manufacturer of this ... (cont.)

I need replacement hinge base for Mepla hinge p/n 346.290.54.00

on the under side of the thicker arm is 41012. The thinner arm has 31876 on the housing underneath is: made in the USA and a date of 07/10/01 11:34 Hope this helps