Viewing all customer Discussions for:

Other

I have Mid Continent Cabinetry soft close drawers approximately 15 years old. I am trying to locate the under mount hardware shown in the photo. It measures approximately 3 1/8 by 2 1/8. Any help you can offer would be greatly appreciated.

37" balancer with above ends and clip

Looking for replacement as multiple broken

Not sure the correct description. Appreciate your help locating these parts.

Like others here, I'm writing to ask about about Pat. # 3750337 sliding closet door hardware. We have only this one top roller-hangar piece (need 4). In looking at the links to photos of available parts you've suggested might work... I just don't see how. Our doors have two small rubbery rollers, wh ... (cont.)

No markings for identification

Simonton double hung manufacturered 04/2000. Sticker says 55DHWH The sash balance box is broken on the right side

Looking for this part. 1 1/4 x 1 3/8 x 7/8. For older window. There is no part number on block.

latch for sliding patio door

Hi, I'm looking for some help identifying the attached glazing bead or a suitable replacement. This is for a 20-30 year-old storm door window. Thanks!

Part says 29 3 DX CMC 7 The metal channel is 30 inches long. Not sure what else you would need to help identify.

need a replacement handle for a sliding glass patio door the door information is Guardian Kingsburg,CaANSI Z97 1-1984 SECC 969 5/32U 16 CFR 1201 II CAN CGSB-12-1-M Thanks

They appear to be nylon and sit at the edge of the lower window in a groove. I circled the item of concern in red. Better BILT is the manufacturer but have since gone out of business.

Hello Swisco expert. If I am correct I will need 2 - 29" series (#351 ? ). The metal channel, excluding plastic/nylon ends is 29". The end pieces are without wings. the bottom is 1' (15-002 ?). The top is 3/4" from metal channel end to tip (19-002 ?). I have attached photos for your conveniece ... (cont.)

I am trying to find replacement glazing for Kinro vinyl windows from a home built in 2002. Everything I am finding appears to be too small.Thank you, Shawn

these pictures are of my sliding glass door rollers. they measure 3 1/8" long 3/4" -5/8" wide, the metal wheels measure in at 1/2" and the concave roller is just over 1/4". I'm hoping you can point me in the right direction. thank you

Looking for confirmation that you have this replacement part.

Good afternoon, I am searching for the closest weep hole cover replacement. The 26-173 did not work out due to measurements, and the measurements of the 26-413 also did not match.

Hello, We need to purchase two right handed and one left handed door locks for our patio doors. The aatached immage is for the right handed door locks. The locks are 7 inches in length and 1.5 inches width. The dimensions of the screw holes from the center of each screw is 6.5 inches. ... (cont.)

This is the mechanism on the part of the door that slides in a track. The door keeps coming out of the plastic roller. Not sure but perhaps the whole mechanism needs to be replaced?