Viewing all customer Discussions for:

Other

can you tell me if you have this part, I need 6 pieces For the slideout shelf/drawer inside kithcen cabinet, on the sides

The back bar measures 21-1/2" as the one you offer. Will the Norco crank fit your replacement or do we need a new one?

Hi, I need to replace this part on my window. The other side is rusted. I can't remove the rusted one yet because I can lturn it to lock the brake. What is this part needed? I need the pin also. Thank youMarshall

I need a balance for my Marvin tilt window. I took this picture of the existing balance. I need the stamp? Thanks.

Wondering how can I find this part? Show's 17 3 ET CMC 2 Is for the window 2 sides

Similar handle on both sides of the door. Has approximately 1/2" drive to operate the latch.

serial number: 501292w

Hi I have a Caldwell channel balance which is 33" long. It has a stamping of 32 5 FQ. What should I order?

Is the part the retained the silinder for the window

The door handle needs to be replaced and we cannot figure out which part to buy.

I need to replace this broken tilting window latch. I think to window was made by Winco.It is a vinyl single hung window that is about 20 years old.ThanksElmer

I have a bifold door that appears to be missing a piece from the top. The third photo shows one of the doors that has the full piece. The first 2 photos show the door that has the missing piece. As you can see, the pin is not secure in the door. I don't know what the missing piece looks like but it ... (cont.)

Hi, i am new in this, what should the replacement part be? Is 35 inch long

Hello, I'd appreciate your help in identifying a broken window operator mechanism. It's a Truth Hardware piece. The long arm is 9.44" long and the short hand with the joint is 8" long. I'd appreciate it if you sent me a link to purchase a compatible window operator. Thanks, Lee

Attached are pictures of a rear drawer slide socket. One is the right side the other the left of the same socket. I need two pairs to fix two separate drawers.Thanks, David

Hello ,,need l and r window operators

Could you tell me what would be the replacement for this???? I found some black ones, but the customer is convinced that they should be gray???

Hello. 2 pics. One showing broken coil, one showing not broken. Can you help me find replacement.

Need help identifying this hardware, determining which part(s) are broken, and where to get them.

I cannot find any identifying information.The screen door is probably 40yrs old- the house is 72 yrs old.Thank youPamela