Viewing all customer Discussions for:

Other

This is for a Merrillat bathroom drawer and the plastic part broke on one of them. The guide is 18 5/8 inches long. The white guide is 7/8 inches wide and the metal guide is for 1/2 inch.

The currenct weatherstrip has number 20755 and says entry guard truth. Noyt sure which to buy

DO you have a replacement ?

The door latch handle is stuck n the open position and I cannot move the handle in any directions. The door was installed in 2000 as part of a complete home Caradco windows and doors replacements.I took the whole unit inside the door jam out and found that several small aluminum parts inside the l ... (cont.)

PC41C is stamped on side Cannot find it in any search. Pictures and measured drawing attached

We live in the U.S, but our home is a Canadian built. We can't find markings on the hardware or windows, but they are double hung. There are several rusted or broken pivot bars and we need replacements. The pivot bar is 3 inches in length. From the end to the middle of the first hole is 9/16. The en ... (cont.)

There are two of these per each glass pane on bottom edge.

This part broke and I was referred to you. The sliding glass door is over 30 years old. The part I need attaches to the door frame.

Need to replace lock set

1/2" channel balancer, 21 inch channel length 1-1/8 inch bottom shoe, no ears on either top or bottom shoe Channel stamped with "20 D" and what may be "BSI" (very small) See photos. I suspect I need a 21-inch model 390 / 2040 balancer, but I figure I should ask.

Photo shows one broken and 1 good sliding mirror door wheel/part

I have been in search of a new screen sliding door handle. Local stores do not carry the part in their inventory. My current handle has plastic pegs that insert into the medal frame, and click together through the screen. Two Screws hold the two sides together through the peg inserts. Would you ... (cont.)

The part that is broken has A12 on it. It's the part that goes at the back of the drawer.

Hello, this is from an aluminum storm window latch. Maybe 30 years old. Spring loaded and has a little rectangle cut into the aluminum frame that holds a small piece of plastic to keep it in place. 2.5 inches long. Was ordered through Menards. Trying to help out an elderly 92 year old friend. ... (cont.)

Hi I'm looking for a replacement part for this operator. I purchased the house recently so I have no information on who made the window. It's about 4" long.

I have pretty much one broken sash in every window in the house. So I need total of 8 sashes for 4 windows. All measure 30 inch tip to tip ( aluminum part only) and width is 1/2".

I think I need 28" SERIES 390 CHANNEL BALANCE based on your website. Windows are circa 1996. Can you confirm? The stamp on the channel is 2730. Another stamp says "8.S.I" I think

Hello, I'm looking for weep hole covers like the one in the photos. Thanks in advance for your help.

Hi, I'd like to replace all the hardware in two Simonton windows that are 51"x28". Pics shown here and also the cranks. Thank you Jeff

Would like to replace entire crank system