Viewing all customer Discussions for:

Other

My current balance is 28 inches please tell me the model I need

The handle seems to be stripped. It spins on the base without gripping onto it. In addition, the base cover comes right off, it's not attached as our other ones are.

I do not find the exact part on the website, I find similar. Does it need to be exact? Part numbers on the part 14. 6 Thank to let me know

Here are pics to our patio door handle. The inside part of the handle broke and we need to find the replacement. The measurement between the screws on the inside part of the door handle is 3/15/16 inches. If you need anything else, please let me know.Brenda/Robert

Dresser is approximately 50" x 38" Drawers are about 14.5" by 30.5" by 8.75" I am in need of all parts for the tracks on all 5 drawers If you need more exact measurements please let me know

2.75 x 11/16 wide x 1.375 H frame w/ 1.5" diameter wheel OA height 1.75 No adjustments. Screws in from bottom with two #8 screws, 2.25" on center.

Hi. Recently purchased and older house with Alenco non tilt windows. Saw your video, thank you very much cause I would never have figured it out. Did what you said and wired fine. I have a number of broken springs. I need 2 springs for the 33 1/2X 25 1/2 window And 2 springs for the 21 1/2 X 17 ... (cont.)

There is a number at every edge of each frame 2755.

I do not know the model or brand of the window. I need replacement tilt out top latch that looks like these. Or any substitute that will work.

The attached pix shows the wheels (removed from the Door). This wheel is the 'good' wheel; it has the white plastic 'thingie' on it.......the baf wheel is missing that....it broke off.....and now the wheel will not cooperate and move the door smoothly.......We cannot figure out what part this white ... (cont.)

I need one handle for my door and roller for the door also.

part of the lock for door

from the inside when the door is closed the lock is then pressed down and the door is locked the part fits into the hold and is helded there by two prongs that fits inside the door to lock it

Looking for a rear drawer socket like in you picture of part 32-119 but needs to be 1" opening for drawer slides which where new for me in 1999. could not find opemning size in your information

The product is Milgard Window product, the handle with latch and striker plate need to be replaced.

Hi- Can you please help identify the product for the attached photos? overall measurement 3"w x 1 1/4"h x 3/4"d

Please help me find this part

need roller IWC brand series 5300

Patti post 01The numbers on the balance are 23 2 BV CMCWe are sending another post with four more photos

I need the whole set up on both sides for the top sash. Looks like each side has 2) coil spring balances connected to the tilt mechanism