Viewing all customer Discussions for:

Other

I am missing the tops to the balances for a double hung metal window. The attached photos show the balances and several photos of the top sash guide. Please advise which balance tops I need. Thanks

The id number on the track is 22E. The length is 23". I need (4) complete with spring and pulley system. I can send you additional photos of the pulley system The track has 6 holes in it. The 1st hole is 5/8" Center to center of rivet. The next hold is 1/2" center to center 11/16" center to cente ... (cont.)

Please recommend which product to buy. Part stamp Caldwell 27 4 E O. I will need 4 total to repair 2 windows. Thanks, Stephanie

Part for Allside Replacement Window late 1980's

They gray T-Lock I just purchased to replace the tan one. The hook on the new on is a little pig to fit in the sash. Is there another size I need?

No cut out in sash

The plastic piece that holds the metal piece has broken.

Looking for 10 sets of channel balances. 2 set for 30DS 35 31" metal length for 37# window. 7 sets for 3040 31" long metal and 24# windows 1 set for 3030 31" metal and 18# window Also needs like 3 metal clips. Please let me know part numbers so I can get ordered.

Hello need these parts for a single hung window. House was built in 2000. Does anyone know brand/make from the pictures?

Possibly Jeld Wen brand windows. Coil is 1/2" wide. The only marking I see looks like a C .They are out of a vinyl wondow that I had to cut a small section out of the top of the channel to remove. Do you also sell any type of cover for the top of the channel after balance replacement ? I have severa ... (cont.)

I need to buy ten replacement vent locks but I'm not sure which ones. Can you help? Thank you, Katie

Looking for as direct replacement as possible. Only need one. As title says, this is an Amerock 502747 with 1/2" overlay.

Please help me to order the correct part. Length is 30 inches. Thank you.

Need replacement nylon rollers for sliding windows. Pacific Industries manufacturer. Home manufactured in 1997.

Right hand replacement parts ?

Help identifying

need a pair

It has a single hole .

Tooling for a top sash replacement piece

the new pivot bar fits the shoe, but when placed in the window is too short to reach the shoe. The older bar round head does not fit the shoe. The installation holes match. Is there a different bar i should use?