Viewing all customer Discussions for:

Other

Hello, can you please help identify which balance I need. The measurement is 30in. The print on the metal looks like 29-9.

Window has 4 little plastic guides that hold window in the middle and are between the window and the track. I am looking for replacement guides that mount near the 4 corners of the bottom window

1. item1 - shower door wheel 2. item2 - shower door wheel's screw 3. item3 - door handle 4. item4 - bar 5. item6 - door handle's screw.

I am unable to find any markings on the door, however on the glass it states PPG Herculite K Trempe Tempered CAN/CGSB 12.1M BS 6206-1981-A

A while back I ordered parts for Windsor windows, appears to be the same where the jamb is removable. Looking for 2 sizes 69 and 54 also mortise lock set and tilt latches. Thanks Ken

These photos are of another window on my house, not the actual one, due to not being able to get on roof. I need approx 72 " of the vinyl beading. Hope this helps! These windows seem to be Anderson, made in 1979. The window I need the beading for measures approx 45" x 28"Thank you William ... (cont.)

Hello,Truing to find a replacement for these. They are 3.5 inches long. There is spring missing from the one in the picture. Can you help?Thanks Frank

Hello,I would like to replace slider handle on two doors due to corrosion.It is 3 7/8 . It can be nickle color or white.Rear KEY IS NOT NECESSARYthank you,Jack L.

I need a replacement handle, can you help me out. Thank you

The handle is broken on the door. I think this is the original door for the home, which would mean it was manufactured in 1987 or 1988. The sliding door measures 60x80.

I have 3 double hng non-tilt windows that are identical. One of them broke--the string. Also looks like the takeout clip died. The part slid down the side of the window, so I removed it without removing the sash. The existing part is 1/2" wide channel, 27" long. The part is marked 26-3 CA2 CMC ... (cont.)

Hello, I am trying to find the best fitting channel balance for a non tilt window. Original piece shows 26 4 LK cod. Please see attached pictures of the old part.

I need a new gear assembly for a Caradco casement window

Yes would you be able to have or tell me what part numbers these are. Thanks. Jeff

Window lock from Sears windows about 25 years ago.. I would also like to know about the pile weather stripping

I looking for a white plastic window lift handle. It attaches to the bottom sash, to help lift the sash to open the window. I attached several photos at different angles. Do you have anything like it?

Looking for replacement part number for the casement window opener for which i have attached a picture of the hardware. Window is hinged on right hand side (From Inside Home). Please advise if you need any additional information.

1147 L (found on bottom of latch) dimensions approx: 1-3/8 x 3-3/16 inches

No markings, but 10" overall height with screws about 8 3/4" separation.

I'm back. Looks like I need one of these too.