Viewing all customer Discussions for:

Other

Does the attached picture look like a 23-026 bottom guide

I need to replace eight balances labeled 26-3 and two balances labeled 26-4. Every channel measures 27" long (metal length). I also need 4 take-out clips. Photos will accompany this post. I'll be glad to supply any additional information you need.

Aluminum part is 26"

Hi, Was wondering if you have something close to discontinued Kohler Focal Shower door bottom guide, part # K10108.01 measures approx. 1 1/2" long x 1 1/4" wide Thanks!

This part broke. It was secured to the slide on a pull out pantry shelf. How can I get this replacement part?

Tilt latch is 3" long 1 inch wide with 2 screw holes to attach. Lock is 3 7/8 " long and base is 3/4 "wide with 2 screw holes lock mechanism extends 3/8 into lock. Finger pulls are 2 7/8" long and 1 " wide with 2 screw holes.

Hi, these were originally purchased from home depot, american craftsman, about 15 years ago. Sizes is 2 3/8" x 11/16". Need both right and left side.

I am replacing all of our interior door hardware with oil rubbed bronze finish. I have three patio swing doors, and I am not sure if I can just replace the interior faceplate, handle and knob, or will need all new locks sets. The house is 20 years old, and these are the originals. I have tried to de ... (cont.)

Good morning, I need some replacement parts for these doors and I can't figure out the manufacturer. I need replacement handles and rollers. Thanks so much for your assistance!!

Do you have this part for my door

Attached is a picture of 2 parts that need to be replaced.Description: The windows are wood double hung windows with aluminum jamb liners and a spring balance. 1970's vintage. The 2 parts in the attached picture:1. The plastic part fits into the side of the sash near the bottom and the sash chord a ... (cont.)

18 windows

I need a Pella sliding glass door handle with lock inside and out if possible all white for the inside or brush nickle

Hello and thanks for helping identify parts Need lathes as shown Need blocks as shown Need pivot as shown I need to rebuild everything on 9 windows...I can identify other stuff from your website. Any advice on removing rusted pivots would be welcome. And if you offer stainless options (home on ... (cont.)

Hope you have what I'm looking for. Looks like the top is 11/16 the bottom is 9/16, the overall length is 2 & 3/8 long and the thickness is 7/16 .

Can you identify this part for me? I believe the shower door is a Kohler. The part is 3" long by 1 7/8 inches high. The wheel is .75" diameter and the opening for the glass panel is 0.5". Thanks

Happy President Day! Hope your weekend was a good one. My name is Cheryl I have attached 3 pictures of my mom's patio door rollers as you can seethey're in bad condition. Can you tell me if you might have these rollers?

This piece came off the end of the right side of a kitchen drawer which uses a rolling track for sliding the drawer open.

Stamp: 29 1 AW CMC 4 steel channel: length 30", width 5/8", depth 9/16" width of top/bottom nylon wings 15/16" depth of bottom nylon part 1-1/8" I think its a Milgard window

Looking to replace a bunch of weep hole inserts that have broken and fallen out of my windows. The color of the window frames is kind of taupe. Attached is a label from one of the windows. If the codes identify the manufacturer in some way, I would love to have that information. Also attached ar ... (cont.)