Viewing all customer Discussions for:

Other

This seal is approximately 5/16 and the T is 3/16, do you have anything or point me in the right direction

I have several of the Ellison 500 vinyl replacement windows. They were purchased in 1998. In several of them the plastic part that connects spring system to window have deteriorated to the point where it no longer securely holds the spiral metal rod that forms part if the spring system. The seller, ... (cont.)

The upper lach on this door is missing we need the correct one to repair the door

my window balance are no good anymore don't even think about holding the window up or snug in place. so need to replace them 2 per window, 4 windows.probably should replace clips also if I can figure out how to take them out.I have added photos hopefully that helps narrow down what I need. also the ... (cont.)

Need replacement springs and the part that holds the mortice lock in place. Thank you.

This piece, sort of like a wedge that secures the non sliding side of the door to the door jam with a screw.

I have 30 JADO locks similar to this purchased 35 years ago. several have failed and I have been unable to find replacement parts. Can you help?

No manufacturer name brand. 29" Long form End to end, Round tubing with spring inside.

PN41131

29inch balances 1/2 inch with 1" foot 6 window panes are 14 pounds 2 windows are 21 pounds All the same height 2 are wider and heavyer Wing on foot broken on one side

Would like to replace these hinges with satin nickel or a non-shiney silver. We are buying new bottom cabinets but re-finishing the top cabinets and painting them a gray. The hinges are not self closing. On the hinge it says. Pat. 1967 CAN. PAT. 3.391.420 There is a B or 8. Also an A with a cir ... (cont.)

I am also looking for a storm window finger latch, which goes to the interior storm window on an aluminum insulated window

We are missing track glides for the window arms. The window does not retract without the piece.

Need to replace balance rods. Not sure which to order. 16 inches long. Thanks, victor

There is no number on the vinyl strip there is MDL 1010 on a label on one of the Alliance double hung windows. I hope that this email is bundled with the original email.

Casement window operator. I can only find "41011" stamped on the arm. Need help identifying

I have window world windows installed by a previous homeowner. I have multiple windows with broken pivot bars. They are series 201/A201 Double Hung windows. The two broken bars that I have recovered are marked with an N on one and a P on the other. The screw hole is starts at 1" into the pivot ba ... (cont.)

Trying to find this roller

I need this piece with the ball bearings. It goes in the middle of the drawer glide. Allows it to slide easily and for the drawer to not fall out.

Looking for a set of channel balances for Series 185SH window. Old balance marking 1720 Length of the metal only frame 17 7/8" long. Window sticker shows: Series 185SH P #029-109 Also need the black plastic top caps