Viewing all customer Discussions for:

Other

Please help me identify the Balance I need to replace my broken Balance Please note that the shoe does not appear to be broken it is just that size. Thank you Thomas

Need to find a comparable part.

Hi, I am planning to place an order for spiral balance and pivot lock shoe Details i have only those photos. I am ordering 29" series 600 spiral tilt windows balance 9/16" and pivot shoe 9/16" thick And spiral charging tool I don't have the exact measurements

I plan to purchase the 39-268 Wood casement window operator and install a screen on the inside of the casement frame with a hole in it to accommodate the crank when needed. Do you have an escutcheon or plate similar to this?

Hello, Could you please help me find replacement part to replace sliding glass door handle for IWC door? Thanks

I need to replace a pair of this balancer shoe.

I have vinyl replacement windows from HD. This one snapped at the bottom below the pivot cam. It has no markings at all that I can see. Can you recommend a replacement?

Please identify the attached picture

Hello I am trying to find a replacement part for a Silver line window 2700 series. The part is the top sash guide. Thank you.

Need these two part to replace broken ones on double hung windows think they were Caradco windows about 20 years old.

photo attached .. need glides .. tks ...m

From a Pella replacement window. I need both sides and screws.

Good morning, hope you guys can help. I've been looking for several hours cannot find one to match mine. The Doors are older National Industries Incorporated doors 1989 vintage .They snap in width is 1 3/8" between the the snap in pieces, it has 2 square Bulb type and 1 flat center fin in the middl ... (cont.)

Looking for the correct channel balance . These are marked 29 4. They are on a PGT non-tilt window.

Looking to replace latches and keepers pictured here. Current ones are all almost all broken. Need 30-40 new ones.

I need several left hand and right hand awning window cranks to the replace the one shown. I have found similar ones, but they do not have the dip or offset or the short bar. I need these in bronze, if possible. Thank you.

?Hi Swisco, I have a 2002 vintage Bloomberg glass door slider with two doors meeting in the middle. From the interior the latch s in right. The thumb turn fits into a nylon fitting which is now rounded out so latch is not functional. The mortise latch is about 3 3/4" top to bottom (latch body 3 1/4" ... (cont.)

Hello, I have multiple broken block&tackle's in most of the windows in my home, so none of them stay up. We took one out so we could identify it in ordering a replacement, but it only says 28D and does not have the multiple numbers that most of the replacement ones we've seen have. It is indeed 29" ... (cont.)

Hi can you guys please provide a reccomendation for a similar match in white please. Thank you

I'm looking to replace this type of sliding door glass lock !