Viewing all customer Discussions for:

Other

Howdy! My casement window operator arm is no longer attached to the window. It looks like I'm missing the pin that goes through the operator arm into the window. Can you advise? Many thanks! Stee

I need several of these to replace broken parts. Please help. I'd order 4 or 5 if possible.

These are Hallmark brand windows approximately 25 years old. Many have a broken seal between the outer and inner panes. On the aluminum edge is engraved MTOL- 91-NC1029-CBA-see picture. Is there a replacement for these?

can't find this particular model number. window is from 1986

I bought some S600 Spiral balances and am looking to buy some more. Who knew the top and bottom windows would be different sizes. Do you have this black foam piece that holds the spiral in the track? If not can you suggest a substitute item. Thanks.

Looking for weep Hole covers for pgt windows.

Hello, At first I was confident it was the Product Code: 82-081 as there is a lock on the outside handle. but the screw hole anchors seem to be closer to 6 inches than the 4 15/16 Please advise

2.75" long, "L" end; from Eagle windows. I can't find something that looks quite like this.

Our window tilt latches have disintegrated due to sunlight exposure in Florida. We are seeking replacement parts.

I hope you have the stud bracket (not sure if this is the name). It is for item no# 39-187 The flat plate it has 2 holes on the left & right. The original is missing.

I have a Milgard Sliding Patio Door that looks like it has a pubchout for an exterior key and lick set. Will the 82-310 fit this door?

This window was installed about 18 years ago. Is it possible to get a replacement for the crank system? Thanks for your help. Jim

Hello, I have a window that weighs 7 lbs. I wanted order 2910 but it's currently out of stuck. Can I use 2920 instead? Thank you, Ken

The multiple windows in my home have the same problem. They will not stay open when raised from the bottom or will drop as soon as the lock is released.The issue seems to be that the balance is broken.These are MW windows installed when the house was new. The house is now 20 years old. I've attached ... (cont.)

I need a 24" bottom track for a slim fold bifold door. It is a one door system for a bathroom closet.

I'm looking for magnetic slide control for a patio door that has horizontally blinds inside the window

Brass spade shaped handle from Stanley Distinctive Furniture mid century modern line built in the 1950's - 1960's. Overall dimensions are 1 1/8" hours wide x 2" hang length. It's marked "A- 3786 DC" on the back. It's from Stanley's line with walnut veneers and white lacquer drawers. ... (cont.)

Wood repair on house resulted in losing tabs for hanging window screens. I can't find a good replacement and aren't sure what these parts are even called. Need help with locating replacement parts (or other options).

my emco forever door 36" sweep is tee shaped and .80" or 13/16" at the tee and has three flexible sweeps at 3/8" off of the tee.it is only 1/16" thick at the tee.

can I get a breakdown of all parts available for this Alenco product? It is a tilt window, I dont see any other identification on the unit itself. I have about 30 windows in my house and several need parts, mostly the guide latch to keep it from tilting. I think it might be a series 600 from what ... (cont.)