Viewing all customer Discussions for:

Other

Sliding door latch won't operate without manually pulling latch out before locking. Looks like small spring inside broke off. Any idea on where to locate this part? Dan

From my research, and I may be wrong, this is a metal parting bead...it seperates the top and bottom sash, is the height of the window, and has a channel that a piece of metal attached to the back of the lower sash slides in.

the wheel itself is 1 3/16" in diameter.

Can these be used one glass storm door

The sliding door in a home I recently moved into is missing the strike plate. Here are photos of the latch that's installed. I'm hoping there's enough information here to recommend a comparable plate.

Hello. I need to replace this lock. The latch moves but there isn't a piece that swings out and locks the window.

I have Best Built (BBI-1) windows, as listed on the AAMA Certification sticker, installed about 2004. An edge view of the glazing and a cross-section with dimension are attached. The glazing is warping and coming out of the channels on one set of windows. Please let me know if you have a snap-in gla ... (cont.)

I have no idea the maker of the window. They are 22 years old. The pivot shoe is 1 1/4 wide, 2 1/4 high, 1/2 inch thick. Has a number 590CSB on it. What part number should I order? In regards to the spiral balance its 3/8 inch 29 inches long. But has no color coding. Is there a "standard color" bes ... (cont.)

Hi there, I need to replace the window channel balances on my window. The balance is stamped 2620, and the channel is 27" long. Can you help me identify the correct channel and end pieces? Thank you.

Hello, thanks for offering this service. I am replacing a broken part and need help identifying the correct replacement. The channel width is 9/16" so I know that is the 1/2" model. The length is 33", metal channel only, plus the two ends. It is hard from me to determine which part number I need. A ... (cont.)

window will not crank closed. Opens fine. Plastic cover piece is cracked.

I need replacement for my Certaintef safety window clipsThese are safety clips. Company is Certsined. I called People Products and they referred me to you. I believe that this Companywent out of business.

Trying to match this latch for a 4p year old casement window. This latch was on the right side of the window sill.

Do you have both top and bottom replacement hinges like this?

I have the above windows and most of the shoes are broken. A few coils are broke as well. I see my shoes are part 15-177 but the notes say to use coil 152-7. The sash weigh about 14 lbs each. Coil 152-7 does not look like it has the correct end. Could you check my work to make sure I'm correct? Is ... (cont.)

screw holes line up but the pivot tab is wrong. don't know the window manufacturer ordered and got pivot bars 26-310 with a code of l-1567-1 but the bar is too wide. what can i do to fix this?

I need help with finding a replacement for the pivot shoe shown in the picture. The best measurements I could get were 1.25" (width) and 0.5" (thickness). I was not able to determine the measurement for the post where the pivot goes in.

Hello. i have two screen doors in bad condition . One was broken but i could repair if i find the right angles and both are missing their rollers ( 2 single roller on each door) . See pictures . Any idea if i can get thoses pieces.Thanks in advance.Gaetan

These plastic guides apparently used to keep the door from coming off of the track when opened too forcefully. The door hits the rubber bumper and momentum lifts the latch side of the door enough that it jumps off of the track. Exposed to west sun, they get brittle after several years and break. Nee ... (cont.)

i need 12 pieces of the replacement for the above part.