Viewing all customer Discussions for:

Other

We are trying to find replacement snap-in exterior grey/terratone glazing for our 1984 Andersen 400 series casement windows (fourth photo shows a close-up) and also replacement molding that appears to be made of plastic and is located between the fixed and casement windows in our home. The windows ... (cont.)

One half inch twenty seven long

barton Kramer door about 40 years old

I need a shower door handle with a double towel bar insert. The numbers on it are n a 81. Do you have this part? Thank you Laura L.

Do you have any snap-in vinyl glazing beads for windows as pictured above? I think my windows are made in 1984. If you don't have an exact match, please recommend any substitute. Thank you

Hi Guys,The little locking switch mechanism broke off our glass slider. I am sending pics of the good slider latch and one of the "broken" latch. I am also including a "crude" diagram of measurements...LOL! The slider is BEIGE in color. Can you recommend a replacement part(s) for this? Let me know a ... (cont.)

Need for double lock

Looking to replace the hardware in 1 set of metal bifold doors. If all goes Well then will need numerous sets to replace in all of my rental properties. Thanks.

I need replacement tabs like the one in the photo. I believe they are 1 1/2 inches wide and 1 inch tall. If it helps, screens for a vinyl Milgard windows. Do you have replacements I can use?

On a single pane double hung window - Single screw holding it down with a spring in the back.

Non tilt balance 3270 BSI DC

My home was built in 1967. The 8' unmarked plateglass slider won't latch. The other windows are all Mayfair. I've replaced the rollers and added a rail cap. The latch and door frame is very worn. Any info would be helpful. David Birchall

Looking for bifold door Pivot pin

Don't see any numbers or marks

Looking for replacement parts for my sash windows. The screw are 2 1/16 " apart. Need the keeper and lock. Thanks Rod S.

Series New Castle XT French PL070-067

The attached photo is 4 views of the top sash guide from my window. It seems to be shorter than your part. Should I use a different part?

i am looking for a replacement for one of my sons window sash locks. As you can see the latch handle broke off and I am including a picture of it. It looks like there is a part number of 30836, but I wasn't able to find that on your site. Please let me know if you have a replacement part availabl ... (cont.)

This home was built in 2003 with Milgard windows. I believe the cranks are Truth Maxim casement cranks. They are for a 16" X 5' casement window, I believe I need a "reverse diad" version, both a LH and a RH. Can you tell me the correct part numbers for this application? In addition, the little metal ... (cont.)

Hello, I'm looking to replace this window spring. See photos. The numbers printed on the metal of the part is: 32-5 CA2 CMC 4 The length of the metal part of the spring part is: 33 inches long Thank you for helping me identify and source this part. John