Viewing all customer Discussions for:

Other

Good day, I need all the window balancer hardware for a window. I have taken pictures of an identical window's parts to try and help. I know I'll need 2 of the giant springs, What does 28D BS1 RP mean? - Which balancer would you suggest? The width/depth of the balancer is 1/2 inch. The end o ... (cont.)

I am looking for a part that stops a casement window opening no more than 4' if someone falls into in to the window. I leave n Memphis and that is code enforcement need for two windows.Thanks Don B

Looking for this track for sliding bypass closet doors. It is 6ft long, house built in 1999.

Hi,I have a customer that has 6 window sashes with what appear to be Series 850 block and tackle balances with black shoes and plastic clips at the top. These are at least 15 years old. They all measure approximately 28.5 inches from the base of the shoe to top bracket and I didn't see a match for ... (cont.)

I need 4 these pivot bars ASAP make that for just in case

I believe these are Marvin double hung windows. Can the metal piece be replaced, or does the whole piece need to be removed?

Looking to purchase a right handed EntryGard - Truth window closure

I need interior and exterior handles and cover plates. Center to center on handle is 6- 5/16". Lock insert is fine

We have wood framed sliding glass patio doors installed my an independent manufacturer (Pullum) in Michigan many years ago. One stationary door section and one sliding. The weather stripping where the two doors meet vertically in the middle has brush stripping that insets into plastic channel piece ... (cont.)

Need to replace existing door handle & lock, mechanism won't function (lock/unlock). Finish worn, Lock set in photos is 25-30years old based on best guess. Could it be the 82-400 series or compatible with it? I measured 1 3/8 wide. 8 1/4 long on plate.

I need to replace 4 of these cranks outs. From a mid 80s Anderson split windows. I have two windows that would need both a left and right The long piece is approx 12? Any help is appreciated

Sliding glass porch door

This is stamped 2730Z. Is the 15-002 shoe that is 1? deep, measured as shown in my last picture?

I am looking for a plastic/nylon replacement for an early 60's Pella awning window. The diameter is 3/4" and the "track" slider is 3/16" tall. The overall length is 1-1/4". The thread on the shaft is about 3/8" diameter. I need a Quantity of Five.

The metal piece is 3" long 1/4" wide. The groove inside is 1/8" wide. The metal piece fits in the white plastic, which was at the bottom of the window. The window does pivot out to clean. The part I am showing broke and the window cannot stay open. There were no markings, numbers or anything else th ... (cont.)

This is a Marshall sliding window lock

I have several windows having broken latches to release the windows for cleaning. Where can I find the same kind or can be used to replace the broken ones?

Replacing my weatherstripping on my 36 inch front door. Both sides and top. What is the right product to use? The local hardware store has the slide in grove for the stripping on the wrong side. Doors are from 1984. Oringinal was magnetic on the top and one side. Compression on the hing side. ... (cont.)

Hello, I need to change the sliding door rollers, are you still sell them? Can you send them to Mexico? I need 100 pieces.

The latch has the number 102 stamped on the back side of it. Can you please try and identify this part. Thanks