Viewing all customer Discussions for:

Other

Hey gang, Looking for this tilt latch button. Thanks, Erik

The original parts are plastic and any wind pressure against the open window breaks the plastic Assy. That the crank attaches to. Need new assemblies.

The guide goes inside the back of the drawer. The left side.I cannot find a parts number. This is an office trailer made by William Scotsman in 2011.Sharon

I need spiral balances with longer attachment pieces at the lower end. I tried the S500 but now I understand I need the S550. I need four 34-inchers, and two 20-inchers. Red tips

Pivot shoe size 9/16 thick by 1-1/4 wide by 2-1/8 tall pivot bar 2-1/2 inches long

Need vinyl window parts for Farley and PGT windows

My acorn. Dorsal must need new rollers as we can hardly open it. Are they available?

What information off the old window do I need to purchase the correct sash balance?

Hello there! I have one side of a double hung sash with a busted balance assembly. The window sash is 22.9 lbs in weight. The balance has the following printed on it: 26 4 KV CMC 9 Pictures attached! PS- Is it recommended to but these in pairs, or can I just replace the broken one? Thanks in advan ... (cont.)

Top piece is partially broken off. No markings or numbers. Channel Length is 31 inches

First picture shows pivot shoe side view and pivot shoe installed in vinyl jam. 2nd picture shoes pivot shoe top view and same pivot shoe in vinyl jam. The pivot shoe is 3 and 3/8 inches long, 1/2 inch deep and 7/16 inch wide.

The bottom of the door- broom? rubber brush ? Keeps bugs out-not sure part is ?

6 total 30' window balancer stamps only says 29 3 Gs Caldwell bed to know how to identify the weight. Thank you.

Window balance on my MM window broke. Need a replacement part. Only numbers I see say 26/4 CX CMC 7

Looking for window balance rod. 36?Lx7/8?Dx5/8?W

I'm looking for 2- Window balances The Number on the it is#1140G 12"long & 1/2" Wide.

30" SHOWER SWEEP WITH DRIP RAIL Product Code: 10-325 The shower sweep needs the below screws to fasten it to the door, but your description does not indicate how many screws it needs. Please let me know. #6 X 3/8 SS PAN HEAD SCREW Product Code: 33-071

Hi, can you tell me which sash balance I need? The numbers on the unit are 11600-17 E499#2710-86 Thanks, Ed

Each slider is stamped with either 2390T-B.S.I.-25 or 2390T-B.S.I.-26. The metal housing is 24 in. long, 9/16 in. wide, 5/8 in. deep. The lower pulley end has a winged shoe, the top has no wings and tapers at a 45* angle. I am thinking these may be 24" Series 350 sliders, but would like to confirm. ... (cont.)

My sliding door roller looks like the 60 49 but it has 60 45 on it. Will the 60 49 work