Viewing all customer Discussions for:

Other

Please let me know if you have this. I need the opposite "hand".

Here are three pictures of my windows. Concerns are son can unlock and open windows so we need additional lock/venting mechanism, and we also want to be able to vent windows. This particular window is mullioned so I took picture of joint. We have 8 single windows and 8 mullioned (16 more windows b ... (cont.)

I HAVE CERTAIN TEED WINDOWS WITH 406 DOUBLE COILS ON EACH SIDE .I NEED A PIVOT SHOE

Vinyl SGD 1 1/2" door thickness, The locking latch is a blade rather then square.

I have Caradco windows in my house, I need to replace a Casement Window operator. There is a number in the back of the casement which seems to be the part number, the number is 40056 RH. I believe RH means right hand. If this is correct, that is the side I need, however the Casement Window operator ... (cont.)

I've attached pictures of my channel balance ends, which I am unable to identify from your catalog. It is stamped 2640 BSI and is 27 inches long. Is this fairly standard? Also, the only problem I have with my channel balance is that the cord broke. I was able to restring it with #18 surveyor's l ... (cont.)

Looking for replacment rollers for Peachtree sliding screen door

This is an early 1980's Andersen window. The crank works fine but the gripper part that slides over the window section to pull it in is broken. Can the piece only be replaced. If not, can the whole operator be replaced? Alice

It's got the Roto logo on it. on the bottom there's a number that says 0P051506

Looking for window latches LH, the size is 2-7/8, 3/4, 5/16 I think it is 26-390. Just want to confirm is that correct based on the image or should it be something different.

It looks like either a 84-011 or 84-073. Any assistance would be appreciated. Need 4 to 8 pieces. Bob

It is off of a large aluminum framed door. Markings on the wheel read: Killian - Toronto Can - Syracuse NY The screw boss in the track accepts the little "Y" shaped flare at the top. There are two screws that hold it in place. I'm stumped.

What face mount keeper should I use for lock 90-133R? Anne

Hello, Can the stopper be installed on sliding windows? Thank you, Murad

The parts arrived sooner than I expected and were exactly what I needed to repair two windows. The two windows are only eight years old and I was concerned that they might need replaced. I deeply appreciate having a company such as yours and the much needed support it provides the homeowner. ... (cont.)

I need a part very much like your 32-334 However, measurements I need are: The holes for screwing into the bracket are 1.5" apart. The hole for the glide is exactly in the middle. It's 1 1/4" tall. The screws are 1/4".

Hello, I am looking into changing a standard interior-locking-only sliding door, to one where you can lock it with a key from the outside. (We have several apartment units that needed to be changed in this manner). From some of the QnA's I've read on this site it seems that you need to know wh ... (cont.)

I would just like to comment on the service I have recieved by staff at Swisco. It has been wonderful. I have not purchased much - just my home needs on my manufactured home, but without your expert staff and inventory it would have been so much more difficult and expensive. I want to thank you a ... (cont.)

I saw a video where there was a cover for a sliding door track and it said to go to Swisco.com....however I cannot find that part on your website. It is a stainless steel track overlay. Can you identify a part or send me the link to that part. There were two, one was pointed and the other was round ... (cont.)

I think screen door roller 84-096 fits my screen door. I have attached a picture of the roller. Can you confirm?