Viewing all customer Discussions for:

Other

Would like to know what this item is called to order replacments. Please let me know if additional information is needed. Norandex, Inc.

Looking for this part to go into the bottom of my mirror. The mirror rolls on a raised track. It fits into the bottom part of the mirror. Tried to include the measurements in the photos. Let me know if I need to send the piece to you.

Hi, Was wondering how water tight the 58-053 bubble seal is or if the foam filled seal would be better for a casement window. Thanks Eldon

I am trying to repair a removable door screen, including replacing the broken corners. I am having trouble finding the right size. I ordered the 11/16”x3/8” Corner (item #95-235), thinking it would fit. The shape is right, but it is not big enough. I have attac ... (cont.)

Dear Support: I would like to buy Rear Drawer Track Socket , 32-009, from you. But I could not tell the size of it from your web-picture. Is the socket big enough to hold 1 ¼ inch track? Please respond at your earliest convenience. Thank you.

Dear Sir, I have several windows that have broken channel balance units. Since we live in Florida we very seldom open windows so this has not been a priority job for me. We built the home in 1988. The tag on the window reads Color Match Building Products, Winter Haven ,Fl. I took one of the wi ... (cont.)

Please identify the part in picture. Diameter of wheel is 1". Width of wheel is just less than 1/4". Thank you.

Please let me know if you have this. I need the opposite "hand".

Here are three pictures of my windows. Concerns are son can unlock and open windows so we need additional lock/venting mechanism, and we also want to be able to vent windows. This particular window is mullioned so I took picture of joint. We have 8 single windows and 8 mullioned (16 more windows b ... (cont.)

I HAVE CERTAIN TEED WINDOWS WITH 406 DOUBLE COILS ON EACH SIDE .I NEED A PIVOT SHOE

Vinyl SGD 1 1/2" door thickness, The locking latch is a blade rather then square.

I have Caradco windows in my house, I need to replace a Casement Window operator. There is a number in the back of the casement which seems to be the part number, the number is 40056 RH. I believe RH means right hand. If this is correct, that is the side I need, however the Casement Window operator ... (cont.)

I've attached pictures of my channel balance ends, which I am unable to identify from your catalog. It is stamped 2640 BSI and is 27 inches long. Is this fairly standard? Also, the only problem I have with my channel balance is that the cord broke. I was able to restring it with #18 surveyor's l ... (cont.)

Looking for replacment rollers for Peachtree sliding screen door

This is an early 1980's Andersen window. The crank works fine but the gripper part that slides over the window section to pull it in is broken. Can the piece only be replaced. If not, can the whole operator be replaced? Alice

It's got the Roto logo on it. on the bottom there's a number that says 0P051506

Looking for window latches LH, the size is 2-7/8, 3/4, 5/16 I think it is 26-390. Just want to confirm is that correct based on the image or should it be something different.

It looks like either a 84-011 or 84-073. Any assistance would be appreciated. Need 4 to 8 pieces. Bob

It is off of a large aluminum framed door. Markings on the wheel read: Killian - Toronto Can - Syracuse NY The screw boss in the track accepts the little "Y" shaped flare at the top. There are two screws that hold it in place. I'm stumped.

What face mount keeper should I use for lock 90-133R? Anne