Viewing all customer Discussions for:

Other

I need to replace my draer sockets which are similar to your 32-014 however, where your opeing to receive the slide is 7/8 mine is 1.13 inches. I haven't been a ble to find anything that wide. Any suggestions?

I need replacement top and bottom tracks and both top and bottom rollers for my four Stanley interior mirror sliding closet doors. Do you sell comparable replacements?

How do I use your product 70-034, for example, to hold a glass storm panel securely to an uninsulated wooden entrance door with single pane glass. 1. is your 70-034 threaded inside hole? 2. does one simply use a wood screw through the hole in 70-034 and into the door while positioning the offset p ... (cont.)

I need several of these but no idea who makes them or their part number. Hoping you can assist. Regards, Jay

Hello! I am in need of some help. I have 2 different window balances that I am looking to identify. These are from Andersen and I do have part of the original invoice that the customer has (I have uploaded the information that I thought may be useful). Please also see the picture of both balances ... (cont.)

Looking for a replacement spacer for window screen. The hard vinal spacer slips into the channel in a window frame for a window screen to make the screen's width side to side properly fit the window frame. Length of the spacer is not important but the width must be pretty exact for it to slip into t ... (cont.)

Have a Neuma sliding door screen sweep. 1.5 " wide with a 1/4" attached square that presses into the vertical track. Seals the screen to glass door when using the screen door.

I ordered part number 91-001 and 91-002, they are not the correct part, the one I have the spring goes behind the latch and as you can see in the picture it has a little rise on top. I hope you can help. Thank you.

I cannot find replacement for this type. I need 5.

This strike plate is 13 years old. I think the finish is brushed nickel. It is about 71/2" from the very top to the very bottom. I need to replace it. It is broken and I live on the water in a very windy spot.PS. The photo is very small. I hope you can enlarge it. It's a photo of the broken s ... (cont.)

I have had trouble matching this

Right open window 39-315 was wondering is this the correct part I need thank you for the help

Hi, I tried to install S795-32 channel balance but the plastic insert where I screw the channel into kept popping out for one of the window, and it broke into pieces for another window. It occurred when I tried to rest the window pivot bar in the 15-194 T-lock balance. Can I buy a few of the plas ... (cont.)

Please let me know the correct product to purchase. Thank you

Photos per previous email

Wanted identify replacement mortise lock and pricing Attached are photos. Door will not open so I do not have the view from the side of the door. Need a replacement mortise door lock for the product. Entryset model: Ashley Norton Model: BZ.SPSGL.800.50 The mortise lock could be either: Baton ... (cont.)

I need to replace the left & right balances and latches for a tilt window. I've attached pictures of the parts; can you please verify what I need to purchase? Thanks.

Please see photos to let me know if you have these in stock?

I am looking for possibly missing parts for this door. Two pins approximately 1/4 diameter, by 5/16 in height are intact top and bottom. When inserted into tracks top and bottom, the pins are about 1/2 inch too short. Is there like a hat, a spring piece that fits over pin or in the track? The holes ... (cont.)

I have the same issue with at least three windows in my home. One is 26b bs1, two just says 32c . I would need all the parts needed to do the entire window as well as a video if there is oe