Viewing all customer Discussions for:

Other

Sliding glass patio door dates to 1966. Original rollers are all-steel and door weighs at least about 100lbs. Wheel outer diameter = 1.25" Wheel thickness = 0.3" Wheel bearing diameter = 0.6" Frame width appears to be 3/4" to 7/8" (not directly measured - see photo 05) Vertical distance from mounti ... (cont.)

Tilt Window Sash Pivot Pin, 2¹/²"

Looking for four screen corner assemblies. All four corners are stamped with #11347 and T/M (in a circle). The reverse of corners removed from the top of the frame are stamped with "1" while the bottom rollers are stamped with "2" and have the long steel spring attached. Looking to replace two ... (cont.)

The metal part alone is 20-1/2". The channel width is 1/2".

The left picture is the part I need- just the cover.

Thank you

Please see the pictures and if you could help finding the right one. It is a L shaped corner piece. Ted

Need a new sliding window for my window. 33.50" long 23.25" wide 1.25"thick It is a double pane vinyl window. I just need the sliding part of the window

We need the below old style continuous hinge offset pivot for our 9 ft Tubelite office door. Do you have anything you can supply us with that would help?

I don't know the name of the part, it is an old cabinet but we are trying to fix the self opening drawer.My name is Humberto

The pins in my windows have rusted to the point that we cannot remove them or push them into the sash. Years ago some of these windows were repaired but the technician at that time used the part in the attached photos. Do you carry this part or point me to someone that does? Thank you ... (cont.)

Guessing door is at least 20 years old. 1 1/4 inch wheel. Screw hole on top. Screw tab on side (screw serves to hold bottom of frame in as well as to hold roller). 1 1/8 inch tall (not including wheel). 2 3/8 inches wide. Screw hole on top is 1 9/16 from right side.

-length is 27" -stamp is 26 4 -I've got an idea based off a side sliding windows sticker - AAMA MFR Code WPI-2 - Cascade Windows, unclear on date -the thing in my hand was wedged in the body of the top fitting, im confused about it -I would need 16

Would you have this part. Probably for the top also

I have various size windows in need of these. They are Alliance windows installed in 2001. Help. Lol Jim

Length is 3" and 1/4" High.

Top portion that makes a "replica" of glazing putty between window frame and glass is at about 30 - 45 degree angle from "snap in spline". The top of this section measures 7/16" wide. The spline runs down the center of the piece and this is what inserts into the window frame to hold the glass agains ... (cont.)

Screen door and rollers are c.30 years old. Rollers are metal, and probably need replacing. No numbers or markings on rollers. Rollers are c. 1/8 inch thick and exactly 1 inch in diameter. Photos included. Can't see any like ours on your site, but willing to experiment with a substitute if you can ... (cont.)

Hi, Hope all is well! Do you carry the following patio door handle or similar? Thank you! OJ

Do you have something compatible with uploaded pics?