Viewing all customer Discussions for:

Other

The metal track not including the plastic ends is 18" length and 5/8 deep, 5/8 wide. It's marked 1720 at the bottom but bearly visible.

Need to find a replacement channel balance for our non-tilt windows as well as the quick release tab covers as seen in pic.

sh-72-1 and sh-72-2 on handles. Need latch mech or replace the assy.

Need to find replacement rollers for my door. Thanks

I need to replace the complete door handle and hardware with lock assembly for this door . Please help me...

I am looking for a replacement for this Truth 40055 left-hand casement operator.

Hi, my tilt windows in my sunroom were installed when the room was added in 1999. I didn't move in until 2016, and they have never opened/closedd easily. Some make a hideous, loud clicking noise when opening. I think I've determined that it is likely my spiral balancing tubes. I've determined tha ... (cont.)

Pat 5,353,548

I have a sliding window in my house that i dont know the brand. I have a bad seal i need to replace. Looks like the seal is 1/4" diameter. The seal is where the 2 windows come together. Do you have something that will work gor this application? Thanks

I've looked at the selection you have and the dimensions dont quite match - is there a close approximation you supply to that in the photos - its very persished.

Good afternoon. I am trying to repair a broken center section if a boat windshield with a piece of clear acrylic. The windshield is an aluminum channel, top and bottom are 5/8" wide, the sides are 1/2" wide. The acrylic panel is 1/4" thick. Do you carry a glazing gasket that would allow me to do thi ... (cont.)

Could you help me to identify what's the right type of coil balance spring and shoes I need to order to replace my current broken spring? it's a double hung amerimax window wv4900DH type, do you need me to get a weight of window? Thanks dehua

Trying Two identify these glazing beads as they are severely out of date and cracking. They look like they belong to an older Anderson window. My guess is mid 80s early 90s. Roughly 68 inches in height.Roughly 3/4 Width. Roughly 5/8 along the back.

I want to purchase a replacement, as my handle broke.

metal is 32 inches with plastic parts its 33 inches the channel is 1/2 wide. Hi i want to be sure i get the right ones. Not sure if there is left and right. i need two please. also do you have a vidio link to forward for instalation? Thanks, Susan

Window frames installed 1970, with Vinyl Glazing

These are drawer slides that were installed in 2004. They were manufactured by Grass. Some of the white plastic rear mounts are broken. I need to replace them.

Need a part that slides up and down It snaps on to the black latch

Can I fix this without replacing the entire handle?

No numbers