Viewing all customer Discussions for:

Other

Looking for this gasket for a sliding glass door. This picture is from a door being sold at Menards. Model is a Chippewa white patio slider. Thank you, Steve

Came from a Milgard window. Has "Truth" stamped in one arm. Look's like several in your catalog, but it is 26 1/2 inches wide, not 16" or 21 1/2". Do you have anything to replace it?

My name is Willie. My shower door sweep plastic part is torn up. I would like to replace the gold plated part and the plastic part attached. It has 1/4 inch T plastic attached to the gold plated bar. Do you guys have a replacement part?

Rollers are 3 inches from front to back .

This project has become a serious pain and we are hoping to find some resolution with these brackets. I think the brackets on the rollers that came (23-264) were flipped over and on the wrong side. This was order 2099434. I'm sending photos of what I have. I have to have the exact thing. I think th ... (cont.)

Looking for the handle for a jeld-wen sliding door. Their customer service think it's a hoppe 3 points sliding door handleset. Reference on the door itself is: G0 306 173013147. Even if it's not excatly the same, anything that would help us not change the whole door would be great. Thank you for you ... (cont.)

Can you assist is locating replacement pivot pin and its keeper for a Malta Vinyl Window from approximately 2000. The pin is 3 inches long and 5/16" wide. Will need at least two pins (one for left and one for right, and the shoe or keeper)

spring that holds door handle up.

Do you have these type of cranks?

Looking for repair 1600-17. E20 9#27 2-85

HiI live in NM and the seal on some of my windows needs replacing ( slightly over 100 feet). Attached please find pictures of existing seal. Hoping you can help.Barry

Thank you.

Missing pin for 3" hinge for Pella screen door. Will accept a whole new hinge set if possible. Your attention appreciated,

I would like to identify my channels. I am sending pictures.

We live in older mobile home with storm windows on sunroom. Looking for latch's. I have attached a picture. Thank you so much

Length of balance is 27 1/16", not sure who made the windows, they were installed when the house was built in 1996.I need four of these, thank you! George

This is for the left side of the window. The balance popped out and I guess the spring sprung up. Will you be able to help me match what I need? Thank you

holds the window to the balance

Hi Swisco team I have an old channel balance from aluminum non-tilt windows with the following specifications: L : 33 in W : ? in Stamp : 3230 Top vinyl : see photos Bottom vinyl : see photos Would you kindly help me find the right match ? Thank you very much. Update-Customer re-measured an ... (cont.)

Hello. The stamp on the balance says: 26-6 HK5 CMC 43. Can you help me find a replacement, please? Thank you for your time.