Viewing all customer Discussions for:

Other

We purchased these windows a while back from Home Depot and are just now installing them. The one has the part where the window lock lever inserts into that is bent/warped. Is there a replacement part for this?

Hi, sorry I don't have better pucs at the moment. I was hoping you might be able to ID the door from these lower guide pin pics and provide a parts list for all the hardware. Or maybe point me in the right direction for how to ID them, I couldn't find a brand or anything. My parents and several of ... (cont.)

Double hung vinyl window replacement locks 26mm x 4mm.

I am in need of 2 drawer track brackets. As you can see on attached photo I have 2 broken brackets. This is for a 2 yr old bathroom vanity.Bracket is approx 1.75in wide by 1.75in deep if that helps.Thanks,Dave

Looking for assistance in ordering the correct replacement parts for Milgard channel balances. They measure 21" in length and the stamp says 20 3 JV CMC 2. And advice would be great.Emily

I am looking for the correct weatherstripping for crank casement windows as in the uploaded photo.

can you lead me in the right direction? window pivot bar.

Looking for a replacement part for Sash Balance on a IWC window

Dear Swissco, We have three windows that are affected and two of them have short handles and one of them has a long handle. This to inquire if you have the parts we can use. If this helps, here is the original serial number for the smaller handle: C-31-56-1/2-1650 ( need 2) The one of the long ha ... (cont.)

We have Oldach windows in our home that was constructed in approx. 2000. Is it possible to purchase T-Handle cranks to replace our crank handles (attached photo of existing crank handle)? The existing handles have the number 45054 marked on the inside (it would be visible on attached photo 6454.jp ... (cont.)

I am looking to replace the wheels on my sliding screen door. I believe you have this part. See the photo attached. If you could give me a good suggestion on what part to purchase that would be great.

I need the window mechanism and the crank handle.

these windows are made by Vetter and have a part which is broken on both sides. not sure what the name of part is, but a small metal rod at base of window slides into the hole at bottom of the piece. the top hook is broken off (and still visible in window slot, although it is sideways) , but shoul ... (cont.)

I submitted previous photos about this project. I ordered 4 - part # 84-106.I replaced the rollers at the top of the door easily.These pictures are for the rollers on the bottom of the door. they seem to be different than the top rollers. There are screws on the edge of the door, but they can't b ... (cont.)

Looking for ADA handle or longer handle crank. Hard to turn crank. 5/16" diameter

need to replace balance in non tilt window, tried going through different company but found balances the had were not correct, were tied to retaining hook instead of crimped, causing retaining hook to catch and then snappedwidest part of channel is 5/8 inmetal length is 27 in marking on metal is 26 ... (cont.)

balance system for 1993 pella double hung window

I am the homeowner and can't seem to find the right outside top piece for our newly installed window , the pieces have become brittle an broken. We need them in clay if possible. Approximately 1" wideEd

You have helped me before and looking for your guidance again. I bought a home with double french inswinging doors that both need new bottom sweeps. I cannot locate a name on the door, but have pictures and measurements (left side 34 5/8", right door 34"). How can I send you some photos so you can s ... (cont.)

More pictures of Anderson sliding glass door weatherstripping. The technician asked me to take more pictures to show the profile of the weatherstripping.. As I stated before in my previous email this door was put in in the early 90s. Thank you.