Viewing all customer Discussions for:

Other

Can you please help source this window balance for a tilted bottom windpow? Approx 30 3/4" long & 1/2" deep. Non Tubular. Manufacturer : Ply Gem Window - 1500 series

I miss placed the parts. Photos are what I have. Numbers you gave me are:S600-19 blue tip75-006 tool15-046 foot. Slot is approximately 1/2"Found the parts the foot is 1/2".

Can only find this stick on the window that looks to be associated with Swisco. Need to replace the lower slide due to the dent in the grid and broken window. Do you sell this part or the whole window? Thanks, Joe

Good MorningI just disassembled the lock in my storm door, for which I do not have a key and is in bad condition. I could replace parts or the whole thing, I am inclined to do the latter. It says on it "patent 4.578.967" and it looks similar except for some cosmetic differences. I will verify the m ... (cont.)

IMG_2474 this is the same mechanism but in a different room. Ignore the small light. IMG_2478 is the window in need with the mechanism remove. The window swings in and out from the top. The rest are images of the mechanism I removed. I would like a more modern and easier to use part. If that's possi ... (cont.)

Hi, One last window latch I'm trying to match and replaced, "Viking". On the latch: 2 1/8" holes on center. 11/16" hole on center off the edge. It is 2 7/8" long and 1" - 1 1/16" wide. I would want to replace the latch base as well. Thank you! Anna

I have an old wood Atrium door patio door. The vinyl glazing bead is broken and I can't find a replacement. I attached a picture of it's cross section with dimensions. Are you aware of anything out there that is close to it. Thanks so much.

Purchased these windows in 1994 and one of them had a seal that wrinkled up.Can you help?Tim

I can't read the final letters/numbers on the assembly due to rust. I think it is ZO. Those last two appear to be letters as they were thicker than the numbers. We have not removed the assembly so I don't have a picture of that but we did take off the "cap" hiding the mechanism and I've sent a pi ... (cont.)

Attached is a picture of sliding screen door track for an Atrium French door. The door was installed in 1986 and has a wooden sill plate. The groove it installs in is 1/8" square.

Hello looking for a white Pella 8 inch Surface mounted sliding patio door handle Item #5216755 Model #1000011487

Need to find this part. I can't seem to find it anywhere.

These are rollers that I am looking for they are for patio screen doors. I would need two of each.

I need window latches 5/8 inch by 2 1/2 see photo

We are looking for this pivot bar. Please let me know if you need anything further from me.

I am looking for replacement parts.

Need replacement part for right side . 5.232.208. 5.365.638 6.584.644 b2 7.5 35" John

this window has a serial number 051-492518, the window was installed in November 2001. There appear to be two stips of metal going from the coils to the pivot shoe.

Hi. One of two casement window cranks broke. Pictures shows the one that broke and the one that didn't. There are no labels on windows, unlike the other casement windows in the house (which are Harvey's and don't look like these). House was built in 70's but all the Harvey windows are from 2002. Th ... (cont.)

Top balance is an 8 bottom is a 6. Shoe has a part number 485.