Viewing all customer Discussions for:

Other

Window sash balance part number needed

do you carry this window valiant. Im looking to replace the one show in the attached picture. Thank you

Please advise that the 22" Series 385 Channel Balance is a match based on the attached photos. Metal = 22 inches long Winged Top and Shoe 8-12 lb sash

I broke my left side tilt in lock and am trying to make sure I order the correct ones. They are snap in I believe. The right side top is 0.965" wide by overall length without lock of 2.43" . I guess after taking the photo and seeing the micro cracks I bettter replace both. Can you also tell me how ... (cont.)

Looking for this

Seal for Sliding Patio Door Desired - white pile weatherstripping with flat material/paper up center (Fabric ?) See picture - actual measurements (could be slightly worn) 1. plastic base width = 0.271" (6.9 mm) 2. pile height = 0.409" (10.4 mm)

Need replacement parts for this window, the window's balance clicks as you raise it up or down. The Balance end is black.

Hello. I m looking for 4 1/4" pull handle for Guildhall by Drexel drawer chest.will be glaad if you can help me. Best Regards Stefan

I believe I need series 795 channel balances.If I'am right the numbers and count are.( 16 ) @ 60" - 27B( 52 ) @ 72" - 33C( 8 ) @ 68" - 31BAs you can see in the pictures, I show the old and new T-Lock Balance Shoe I have replaced from you, in some of my windows all ready. But I'am still having troubl ... (cont.)

Good morning, Would you carry a replacement for this window corner? It has two screws that hold it to the top part of the frame. The top screw is the longest that threads into the top rail. This piece includes a sliding safety lock but is not necessary. It is used in conjunction with S390-28 Channe ... (cont.)

Hello, I'm looking to get a window repaired that doesn't stay open. It looks like the string cords on sides are both cut and I'm not sure what part I need. If I just need to replace strings or the whole mechanism? There is a number on the side of the bar that holds the string from the looks of it ... (cont.)

Here are the pictures you requested in order to help me identify which balance to order. There is a "26" stamped on one end. Let me know how to go about ordering the correct ones. Thank you so much!

I am rebuilding the windows in my townhouse with new spiral lifts and window slides. THe slide I removed is in the photo on the far left. THe others I recently ordered from you as comparison samples. -THe one with the white circular pivo lock (15-046) is the closest, however it lacks the edge "rail ... (cont.)

I just bought a house and all the bi-fold closet doors have these clips holding the pins in place. I found part # 21-154 and they look like they would work. Do you think they will?

Looking for latch and handle assembly for NAMI- 302187 door.

Need replacement for this.

The number on the balancers (right and left) are the same: E33 9P27 277. Can you tell me what the replacement is. I can not find this part.

I am attaching pictures of our weather stripping. Wondering if you have this in a beige or dark brown might be even better. The measurement of the top of the leafs is 7/8" and the tail that goes in the groove is 1/4". Let me know. Thank you

We have 1 vinyl window approximately 17 years old that will not stay open due to broken parts. The lower window tilts in for cleaning and removal and the top window is fixed. We need information to replace the balance and sash. The lower window has a height of 36.5". The metal channel that allows t ... (cont.)

Need gasket replacement to two Andersen Bay Windows.