Viewing all customer Discussions for:

Other

I went to home depot and bought 3 81 inch strips but they dont fit into the groove on my door. They kept falling down.

Hi and thank you for chatting with me this morning. I over cranked the skylight pictured and snapped the spline shaft that extends from the skylight to the hook that I attach to with an extender pole. Is there a simple fix? the spline shaft is ½ in diameter and enters the hook which is ½ with int ... (cont.)

Hello, I'm looking to get a price on replacing this door nosing weatherstrip. I would like the black portion and the fuzzy weatherstrip.

Our Pella Designer Series Door Hardware is badly corroding on the outside. We'd like to replace at least the outside hardware on 3 double doors and 1 single door. These have a 3 point locking systems. Thank you!

I am trying to replace the attached Flush Mount Window Lock. The dimensions are the same as your 90-298 (1-5/8") lock but, as you can see, my lock is screwed from the front of the lock, rather than the top. Do you have a lock with the 90-298 dimensions the screws in from the front of the lock? ... (cont.)

I'm looking for a replacement of the part I included pictures for. I need this coil to be 72" long.

I need to replace the slider for an awning window. I can't find any visible numbers or names of the manufacturer. The house was built in 2007. It is just the slider that needs replacing. Thank you.

We need a replacement handle for a sliding glass door which is named PPG Herculite. Lock mechanism is what's actually broken, do we need a whole new handle or just a lock replacement? The distance between the two attaching screws is approx 3.75 inches. The thickness of the door is 1.5 inches. ... (cont.)

I recently purchased 26-416 for a Harvey window. Apparently, I broke the originals when I tilted the window when it was all the way at the bottom of the track. I replaced the pivot bars and then installed them with the window up about 8? ? however, they twisted again (and almost broke) when I reposi ... (cont.)

no pic

We cannot determine how tO remove this sash in order to have the thermopane section replaced. The white metal frame slides into side channels with no way of determining how to remove the sash--the upper and lower sashes are stacked over each other in the same channel. The label inside the window i ... (cont.)

I've ordered this part with the numbers 30830 and 30841L TWICE now, this will be the third time. Both times it took a week to get them only to have them be the wrong replacement part. It has 30830 on where the cork screw cover is and 30841L on the 2 piece arm (photos attached). I need 2 of these. My ... (cont.)

Hi! This had a metal tab with a hole in it that broke off. Plastic or nylon wheels go along a little ridge on the aluminum door track. Door originally installed in the 1960s we think! We didn't find any markings (the glass was replaced years ago so perhaps that was where the markings used to be) ... (cont.)

Not sure if this is correct crank

Hi I need 18" Caldwell Series 300 5/8" Channel Block & Tackle Window Balance - Stamp 17-4 And 13" Caldwell Series 300 5/8" Channel Block & Tackle Window Balance - Stamp 12-2 Both with winged top and bottom guides 1 pairs of each please with total cost Thank you.

Our patio door is oversized. It's called a "Wisconsin" patio door, but has no markings for manufacturer.

Good morning, could you please inform me of the replacement parts for these items...Thank you

I am needing two Block and Tackle replacement for a EMCO storm door. I did not find any part numbers on the door or balancer other than the door is a EMCO and the balancer is 36 inches long as shown in the pics. Please let me know if you have replacements. Dave

These are 30" long with stamps of 2930 (smaller window) and 2950 (larger window) - based on your site it looks like either S380 or S385 to me. Appreciate any suggestions to get the right ones ordered. Thanks!

I have three of these windows, photos show two of them. The window latch and tilt-in latches need to be replaced. There is also some damage to the window frames, wondering if there's a way to fix the vinyl there. Lastly, at least one of them is missing a balancer - is it possible to find a replaceme ... (cont.)