Viewing all customer Discussions for:

Other

Can you help me identify a replacement latch for these windows? I measured them to be roughly 2-5/8" in length.

Connects to metal roller and ensures smooth close. 2.5 in by 3 in.

I know I have purchased these parts from SWISCO in the past but can't seem to find the part again. I have 2 corner reinforcements that have failed. They are made of plastic and fit into the corners of the panets to prevent the door from sagging. Needless to say, the door is sagging. ... (cont.)

Slider circa 2004. Dome head bolt spacing = 4" Only marking: Patent Pending

See pictures. Bottom boot is 1 3/32 deep. Metal length is 32" 1/2 inch channel. Window weighs approximately 25 lbs (maybe slightly more) I'm thinking the S385 but want to be absolutely sure.

I have double hung tilt windows that were installed in 2002 or 2003. Parts are starting to fail and need the tilt latches and other parts as well.

Part has 0910 imprinted on metal pieces

Please help me indentify this balance.

Google Lens said it might be a Blum soft close hinge for a kitchen cabinet door. Can you help?

One of my window sashes doesn't stay in place and keeps sliding down. These windows were replaced before I got the place and have no markings for the manufacturer or the coil mechanism. Attached are pictures from the broken coil spring (both sides are broken and the coil is out). I've attached a pic ... (cont.)

Could you please help me identify the correct 25" channel guide? Thank you!

I would like to try and replace only the bottom window sash.

Windows are alenco. Thanks for your help.

This latch is 1 5/16" long and 9/16" wide. The two prongs that snap into the window mechanism are 5/16" long and centered below the thumb latch which is also 5/16" long. I ordered some latches from you a couple of years ago but they are too small.

only need the door handle not the complete set with the other side with the lock

Outside 5-1/2" distance between center of handle and center of cylinder 8" distance plate screws inside 2" distance between plate screws on both interior handle and interior thumb turn 1-1/2 door thickness

Mm (millguard) coil balance. Need help identifying replacement parts

I have 3 patio sliding doors where the locking mechanism no longer works. I would like to replace them. It looks like they are a SWISCO product. Can I order replacement door handles from you that will fit?

Needing some help identifying this part

It is broken ? I'd like to purchase several in the event others break as well.