Viewing all customer Discussions for:

Other

I need two of the following Imperial Window latches. Can you let me know if I can order them from you? I had trouble finding it on your parts list. It is similar to one on the SWISCO inquiry I found by a Google search that Paul (Swisco) answered just longer Thank you Randy

Hello, I recently ordered item 82-261B - Handle Set with Plates, 3-15/16". I was wondering if there are instructions for installing the handles. There are many different screws and can't quite figure out what goes where. Here are photos of my balcony door, the holes are indeed 3-15/16th apart: ... (cont.)

I have an andersen 200 perma shield sliding door, I need all hardware, but it does not need to be keyed if that saves money.

Believe the small bath widow is 18" (the moving pane)high and @ 21.5" wide and built by EPI. Need balancer for left side (see pics) The slider was also built by EPI. The slider handle/latch mounts with screws 4" apart. Need full replacement for handle/latch. (see pics) If additional info is needed ... (cont.)

Can you please ID this? I looks like it might be the SWISCO, Bubble Weather Stripping 58-183 .187 T-Slot Offset Hollow Foam Seal,12ft

Can you please let me know the name of the part I am looking for and the part numbers if you carry it? thanks.

Hi Crank broke off this window we were unable to reattach it.We would like to purchase a new mechanism and hope you can help us find it.ThanksShawnee

I hope you can help with this drawer guide. It was installed new in 1987. I have been all over town and no one has been able to help.

The plastic pieces slide in it's own track at the top of the door frame.

Hi! I need to replace kitchen drawer bracket (right side). There are no name or number on the bracket, I have attached picks of the broken bracket, thanks, any help is greatly appreciated.

We have window world windows. Renter broke the plastic part pictured. Plastic piece 1 1/2 x 4 1/2 Inside snaps into 3/4" track. Can you help us find a replacement piece? Thanks!

The window is 36" wide and I'm not sure of the brand. The spiral balance has a red end. I'm just not sure how to measure the pivot shoe for replacement. It is a double hung window and will not stay up. The first photo shows the broken pivot shoe and the second photo shows the "good" pivot shoe. ... (cont.)

Window rail and rollerwilliam

The crank screw on my Pozzi window came out. I can open the window but when I close it, the screw comes out. Can I tighten it somehow, or do I need a new crank? The windows are 16 years old. Thank you Chris

I need to replace this part. It is 1/2 inch wide, 1 inch at plastic part. The metal is 33 inches in lenth with plastic parts is 34 inches. Do you have this part? and also can you tell me the brand of window it comes out of. I recently bought this house and don't know the brand of the windows. ... (cont.)

Single Hung Vinyl Window does not stay up. One side of the Channel Balance Top was broken.

Hello, Looking for replacement pile weather stripping for some old aluminum sliding glass doors. I haven't been able to figure out who made these doors and finding parts has been tricky. It looks like the weatherstripping is 1/4inch by 1/4inch. Thanks for any tips.

Looking to find a replacement tilt window sash pivot bar off a late 90's Care Free window.

No.D/3137028 A/S3097401 Plastic will Kilian By RAQUEE.N.Y.

My home has Anderson Tilt Windows from the 1960's or 1970"s. The windows have storm window inserts that are held in place by four (4) fasteners. Each fastener is attached to the frame of the window using a small screw. The picture of the fastener is shown above. I am looking to replace about 64 fast ... (cont.)