Viewing all customer Discussions for:

Other

Hi I would like to purchase new top weather seal for my Milgard windows. The T-Bar hard plastic strip that locks weather seal in place is 3/16 inch. The bulb is 1/4 inch. The fin is 1/4 inch. Thank you for your help. Tim

Hi there, I am lost as to which screen corners would work to replace the old ones here. Thank you!

33.5" long metal to metal Channel inside width .5" Markings on existing spring balance: "33 9" "BSI RM" Window this balance will go into: Milgard Manufacturing code MG-1 Series: 3210 SH Product Line # 032 -15(unreadable after this) I have additional photos if necessary

Please help me find operator for pics sent under help@swisco.com

The picture I'm sending it's of a good (not broken) tilt key for a storm window. The tip of the other one broke off and I've been looking for this type of tilt key to fix the storm window but I can't find anything that looks like it. Could you help me with this search? Thank you! ... (cont.)

I have a 22lb Milgard window & I need to replace both balancers. The balancer has the marking, "32 4 BX CMC 7" The balancer is 33" long

im looking for this seal and can't find it,

This is a casement window that goes out. There are no markings on the window to indicate the manufacturer.

Single pane aluminum windows from log kit home (like Justus Cedar homes) possibly bought from sears. Metal insert installs into vertical channel with a flat roller wheel at bottom, windows slide sideways. Phillips screws into nut to tighten against channel at top of insert. Sending pictures. Hope yo ... (cont.)

Printed as "32 4 EV CMC 7" 33" in length.

Please help to identify this 27" sash part # so I w could purchase 6 from your website. Thank you!

Can't find replacement cranks for my awning g wi dows.

Hello, Looking for new mortise lock and thumb lever, your 82-218 lock seems to be a close match dimensionally but not was not able to identify the lever Please see attached pictures Thanks Lloyd

Hello there, I ordered six S385-27 tracks based on the length of the ones that were broken but, they ended up being an inch too long so they don't work, the hook in one of your tracks snapped off in my hand, the knot holding it was not good.One of your representatives said that I need a different tr ... (cont.)

These are my bathroom windows that will not stay open . Not sure what parts I need

Latches for glass vent panel on a forged iron entry door

Please help identify weatherstripping.

The pictures show the hardware that I need replacing. No serial number or other identifier. Will need some 8 of these crank operators. In case of any question, please contact me

Hello, I need a couple locking pivot shoes. The windows are 24 years old and have no indication of brand name. I already ordered 15-134 - Pivot Lock Shoe, 3/8" Thick, but it did not work because the hole was too small for the bar coming out of the window. The dimensions of the locking pivot shoe is ... (cont.)

We replaced our windows in 2001. Attached is the paperwork that I have, I can't find any part numbers. My husband disconnected the coil ends on the bracket and I can't get to the end of it to pull it back up. I would like to order 2 of the (what I believe are)/the coil housing pivot and coil balance ... (cont.)