Viewing all customer Discussions for:

Other

need a replacement handle for a sliding glass patio door the door information is Guardian Kingsburg,CaANSI Z97 1-1984 SECC 969 5/32U 16 CFR 1201 II CAN CGSB-12-1-M Thanks

They appear to be nylon and sit at the edge of the lower window in a groove. I circled the item of concern in red. Better BILT is the manufacturer but have since gone out of business.

Hello Swisco expert. If I am correct I will need 2 - 29" series (#351 ? ). The metal channel, excluding plastic/nylon ends is 29". The end pieces are without wings. the bottom is 1' (15-002 ?). The top is 3/4" from metal channel end to tip (19-002 ?). I have attached photos for your conveniece ... (cont.)

I am trying to find replacement glazing for Kinro vinyl windows from a home built in 2002. Everything I am finding appears to be too small.Thank you, Shawn

these pictures are of my sliding glass door rollers. they measure 3 1/8" long 3/4" -5/8" wide, the metal wheels measure in at 1/2" and the concave roller is just over 1/4". I'm hoping you can point me in the right direction. thank you

Looking for confirmation that you have this replacement part.

Good afternoon, I am searching for the closest weep hole cover replacement. The 26-173 did not work out due to measurements, and the measurements of the 26-413 also did not match.

Hello, We need to purchase two right handed and one left handed door locks for our patio doors. The aatached immage is for the right handed door locks. The locks are 7 inches in length and 1.5 inches width. The dimensions of the screw holes from the center of each screw is 6.5 inches. ... (cont.)

This is the mechanism on the part of the door that slides in a track. The door keeps coming out of the plastic roller. Not sure but perhaps the whole mechanism needs to be replaced?

Hi, I need to replace these two on my window and found the number on the channel is 27-4. I no longer have the metal hook that attaches into the slot on the window frame but it looks like the image from your website which I also included in my photos.

Only one window

This is a window ballancer and it it i written 10R.

Looking for the shoe for this window. It's from a mobile home window. It had a spring connected to the top hook. Not traditional channel balance. Only identifier on the window was it said "care free" on the lock. Size: 1" wide, 1-1/2" tall plus 1/2" hook on top. 5/16" thick. 5/8" cam with 3/16" wide ... (cont.)

We have an inexpensive sliding glass door. We cannot identify the manufacturer. Marking on the door is "JW". The frame is aluminum and the door handle is heavy cast metal. The lock inside the handle broke off. The company that installed the door no longer works with this manufacturer. They sent us t ... (cont.)

Sliding Mirror Door Bottom Track

Need a 15/16" Sliding door Glazing strip. Not the 3/4" glazing strip part 55-164.

Resending since I didn't see my post

Hello! I can't show you the part I need uninstalled because it's still (barely) holding up the shelf. The cabinets were installed before 1992, and I just noticed that the right side of one shelf is suddenly uneven. Uh-oh! The pegs/brackets are rectangular & white, but I think I'll replace them a ... (cont.)

Need help identifying which one I need..

Bracket for a side mount drawer guide 2" tall 1.5" wide 3/4" total depth 2 round parts in the back stick out 3/8" past flat back. They are 1/4" in diameter.