Viewing all customer Discussions for:

Other

Block and tackle . Metal channel is almost 16 inches long. The stamp is 154.0 The metal channel is 9/16 inch wide and 5/8 inch deep

I believe that I have found the 1" sliding shelf spacer that I need- 32-339. I was wondering what screw is appropriate to attach it to the slide. I've attached images of the screw I have now that secures my current broken spacer on. It measures 1/2" in length.

Marking is 2600 BSI (maybe BS1 or BSL) for the bottom sash and 2200 BSI for the the upper sash. Looks like the balance shoe is damaged on some of my windows also. These are tilt, vinal windows. Have 8 windows need to replace all 32 balances (8 left lower, 8 left upper, 8 right lower, 8 right up ... (cont.)

Hello al do you cary a replacement seal for this window? Its a 1980s pella casment window. Thanks Daegan

1/2 iinch wide, 26 inch long.

Hi! We are looking for a replacement for a broken kitchen drawer rear mounting bracket. Help, please? Thanks!

On the tilt latch there is a 30L and 34R on the other part I did not see anything. I believe they are wenco windows from like1997 I purchased from Menards.

Would like to make sure I get the correct part

I measured the width of the bottom plastic piece at 1 3/32 inch. I measured the entire length of the metal channel at 29 inches (despite the inscription calling it a 28). I tried to include more pictures but was limited to five. It's a half inch wide channel. I identified it as S385-29 for a non-til ... (cont.)

I need a couple new bail pull parts for my thomasville dresser. Any help would be greatly appreciated.

Need a window balancer for 26-05. Please recommend one

I need balance tension rods for 5 windows. All PGT and all the same size

Need 4 mine are broken part #?2855260/2857233

Please help to identify this one

1. Window Lock - Entry guard, Truth, U.S pat 268.643 2. Tilt latch P54, P55

Clip to hold window in

casement window operator RH spline. Cover broken. Handle is good. Need to change operator

trying to find replacement rollers for the bottom of my horizontal sliding window. there are two of these on the bottom of the window. the roller assembly appears to be about 2 1/4" x 1/2 x 1/2 The rectanglular opening slot is 2 1/8" x 7/16". there's a label inside the window frame that says MFR: ... (cont.)

Need the right balance

Need replacement window cranks