Viewing all customer Discussions for:

Other

Hello, I am looking for about a dozen tilt latches as seen in the picture. I am unsure of the brand of the windows, but they are newer insulated ones that were installed in the '90s. If you need anymore information, please let me know. Thank you. -Nick

Could you kindly let me know the part number and cost for the window channel balance replacement part as described in the 5 attached photos?Length (metal end to metal end): 33"End width (plastic part): (1 +1/16)"Part info printed on original window balance: 32 5 DV CMC 7Thank you very much!Qiang ... (cont.)

I'm looking for this part for a PGT hurricane proof window

Hi- I have several screens like the one in the photos where the pulls have broken off. What pulls would you recommend I use as I will be re-screening the ones with the broken pulls. Thank you.

I have 2 block and tackle parts that need replaced but I'm not sure what part to get. The marking on the channel is 28 1/4 3 HJ CALDWELL

Number stamped on the item is G6600

Can you please help me locate this Sash Lock please. Thank you

Hi, I'm looking for the correct door lock replacement for our Schlage SGD- R35 71 x 80 sliding glass doors. The 82-265 looks like it will fit based on measurements if I don't use the white cover plate in photo 1. What is a good replacement lock to fit with 1 3/4 center holes with the 82-265? Or do I ... (cont.)

I have no idea of the mfr of these window screens. Not sure of age, other than older than 16 years. Possibly 50 years? At any rate, the corners appear somewhat similar to the corners you have available. The seem to measure 15/16 x 5/16. Ive needed to replace corners for over a year. (I actually glue ... (cont.)

This is from inside the lock. Thanks!

Please identify part to be quoted. Material: Plastic This part has the 2 treads broken and attaches onto the frame with 2 screws

mortise II made in New Zealand h=7" w= 1 3/8", 1/2" thick

Good afternoon, I need to replace all the stays in an old house. They are all the same, just mounted in a different configuration based on the window opening. Do you have something like these?

Need drover slides 13 3/8 long 1inch wide 1/4thick

I need 1 of these

This shoe is from a Louisiana-Pacific window and parts are no longer available from that distributor. The windows are from the Astoria Collection, Model 2848. The springs have a red tip and are 33". I have also included a photo of the guide that is attached to the window. It needs to slide in from t ... (cont.)

Can you identify which balancer this is?

i have entryguard ingraved on it. looking for2 replacements one is 30842R and the other is 30841L the long arm is about 9 inches long

I am searching for the Pella glazing bead. Do you have a google account that I can e-mail the photos ? Thanks, Danny

I am in need of a replacement part that is attached to the shower door. I did receive the replacement rollers, but the piece attached to the top of the shower door is cracked off on the other side. Do you have those pieces in stock?