Viewing all customer Discussions for:

Other

Hello - this door was installed by prior owner - cannot find any sort of Andersen ID. Internal part of lock set is bad so door handle hangs low, and therefore the door wont fully close/stay closed without locking it. I assume the internal mechanism is worn down and needs to be replaced. I also re ... (cont.)

The spring on this latch has broken. The latch is 3-1/2 inches long, is made of aluminum and is powder coated in white. I need some new springs for several windows. Do you sell them? If not, where can I get them?

Can you help ID this weatherstripping for the same window? The metal portion is 16" long and is roughly 1/2 by 1/2 an inch, slightly over. The stamp says 16C BSI. Open or closed cam, I am not sure but here is a pic and i think i should replace the entire unit as on of the cams has a broken pie ... (cont.)

Do you have this part available? Rear soft close drawer latch

Need replacement slider handle. Color not to important. 315/16 inch between installation holes.Saw the 82-030 new style. Would like to keep older styler look.. have two of them..Paul

Hello, This is a shot in the dark here. I am trying to find a replacement strike for a discontinued Jeld-Wen EX swing door. See attached pictures. Any help is greatly appreciated! Thank you, Aidan

Please help identify and locate replacement(s). Right window's crank plate is cracked. Have two casement windows, so ideally need two sets. No manufacturer, logo, numbers visible from this angle. Will be eternally grateful.

I'm trying to find a replacements parts for : Andersen PL16124 1" x 15/32" White Plastic Screen Door Frame Corner. Also, Anderson Rollers for a screen door repair. I would need (4 of each) Thank You,

30" metal channel 1/2" back 5/8" sid, 24lb impact glass aluminum framed window, does not tilt. with winged ends.

I need the attached picture part for sliding pella doors with the blinds between the glazes, I'll call it a blind operator.

I need a replacement stud for a window stay. The wooden window is hinged at the top and opens outwards. The stud recently broke after just nine years use. I understand that Jeld-wen has ceased production in the UK and I am unable to contact them directly.I can provide a photo if required.Many thanks ... (cont.)

I'm looking for these styles of sash and can find anywhere. If you can tell me something about them I would greatly appreciate it or if you have them in stock please !!!

I'll need about 10 pairs if we can work out what will fit. Thank you for your time and attention. David in Tx

We moved into an old house at least 80 years old the window cranks are broken. The picture hopefully should show you what you need and the name on the arm was entrygard truth. Thanks Ed

Looking for this type of clip securing glass panel

I have a couple of check balances from my window that need replaced. Condo was built in 2004 if that helps. Stamp on Check Balance says 26 5 IW CMC 11They are 1/2 inch wide and 28 inches long to include plastic tips on either end.I've included a few pictures If you need anymore info let me know.T ... (cont.)

Hello, I spoke to Steve earlier today, seeking advice on how to replace our vinyl strip at the bottom of our shower door. I have not been able to find an exact replacement. The vinyl strip keeps coming out of the track. Thought a new vinyl strip may help. I also realize that I may have to replace ... (cont.)

Andersen mechanism looking for replacement parts

Pictured pivot pin is intact pin from double hung bottom sash. I found name on one sash showing Simonton windows. Dated 8/7/00. Also showed Sears siding & Windows/Knoxville. I purchased item # 26-241 thinking it was the same part but realized when they arrived it did not have the double nipples of ... (cont.)

Where can I find these exact models?