Viewing all customer Discussions for:

Other

After investing time and researh into a viable replacement, company reps had no plausible fix or replacement. Willing to have some alternitive secure (exterior) retro lock assembly. Too exspensive to replace entire 9' full glass enclosure to 3 season room. Your help or advice will be greatly apprec ... (cont.)

I need roller replacement for my sliding glass door 5502-xbl if u can contact me

I am looking for a replacement for this wheel assembly for a residential sliding glass door.

We recently replaced Kenlin sockets with your part 32-082. They worked great but found that the piece pictured was also broken in a couple drawers. The part needed is at the end of the rail and stops the draw from being completely removed with just a pull. Hope you can help. Thanks ... (cont.)

In need of replacing foam seals between bottom of window and sill. We purchased windows through Home Depot in early 2000s, pretty sure they were American Craftsman. Thank you, Lyle

I have a Larson Storm Door and the latch has worn out and the spring no longer retrives the latch to normal position. I am looking for the latch assemby that fits the 5 and 3/4 in mortis and is 2 inches deep into the door frame. See the picture attached.

Would you be able to help me find this roller or andequal?

white 1/4 bubble seal 1/8 slot in window

Concealed hinge is 90 degrees we have relocated the cabinet in our kitchen and need 8 hinges to open the cabinet greater than 180 degrees to access items in cabinet easier. Thank you

Can you help me identify what channel balance I should order? Non-Tilt 9/16" channel balance Length of Metal Channel: 27" Stamped on Balance: 26-4 BL5 CMC 43

I need the lock/latch replacement for the back sliding door. It measures at 6.30 inches 6 1/2 inches. Black. Please let me know If you have the part I need. Or if you need another photo. Thank you

i need 4 of these (window made by Mr Glass).

It looks like your Skylight Operator, angle drive might be what I need. Does it come as a right-side unit also? or will this unit work on both sides? Picture attached. Mahalo! Kimball

Hi, I would like to know if you guys have this part. This is a cabinet drawer. See the pictures. Thank you

I need this part for 4 windows. The picture only has 1 of the 2 .

Photos from a Link-Taylor chest-of-drawers. There is a part number on the pull. It reads A3404DC

Hi. House was built in 2005 and has original Kinco windows. One window has faulty coil mechanism on one side. Attached are pics of the label and the 'mess' on that one side. Also a pic of a good plastic coil mechanism from the opposite side that seems to be fine.I am not sure what to do. I can re ... (cont.)

Screw holes - 3 15/16 in Top screw hole to lock hole 2 11/16 in Width 1 in Length 8.5 in

I believe this is a pivot shoe but I'm not sure the parts I need. No numbers or markings on it. Thank you for any help!

doors are 30+ years 30. the rollers do not screw into the frame. how do i get them out of the door. I believe they snap in but not sure. this is the best picture i can get. i am afraid to pry them out of the frame in case i am wrong